sold some stock taillights and found and installed a rear window on my shell.

 

I vinyl wrapped the top part of my hood and repainted the underside silver...

 

Not on my truck ,but a Toyota. My 94 Corolla , just had the engine changed out after 308,000+ miles had to change the engine. Got another out of a 97,with 150,00,on it,runs great,even get more MPG. But a shake @ high speeds. Toyota told me to change the output shafts ,so that is what I am doing!! A real pain in the ass. Now have to change out the lower ball joints ,as had to plasma one off!!
Hope to have done tomorrow!!

 

I put a "Big Tex" refrigerator magnet on my 1995 Extended Cab Truck in honor of the State Fair of Texas icon that burned down last week.

 

Bought new tires for the truck. Only tire that was holding air was the original spare from 77.

 

Got the new output shafts & ball joints in on the Corolla ,& the shake is gone!!!!!!
Good for another 100,000 miles!!
309,000 on this pup now,new ( old) engine with only 150,000 on it!!!

 

removed the bed liner and cleaned the crab out of the bed. now trying to decide on putting this thing up on craigslist for free or tossing it out in the dumpster

 

Ok, now I've got to get the bedliner out of this 95 Truck that I just bought.

 

installed new window regulator in the drivers door along with a cherry weather strip i got from a donor truck in the local pic-a-apart. passenger side window weather strip got 1/2 way removed and reinstalled so that it seats correctly. brakes and ball joints (along with flipping them) are next on the list...

 

sat in my living room polishing ancient beauty rings for my rims. hopefully can spray the steelies black tomorrow. Need to find the $35 for the blocks so I can get a little closer to mother earth soon

 

Change my spark plug and wire...put some NGK

 

I replaced my radiator. It was the factory one and lasted 19 years and just began to crack.

 

I did full NGK wires and plugs, works like a charm

 

Wat type of NGK spark plugs did u use

 

I used some v power in mine.

 

pushed it out of the shop so i can insulate the shop

 

Got started on my winter projects ,pulled the bumper & stripped the paint where I will be welding! Pulled the corner lights for modification!
Next into the bed area !

 

Fixed a short in my stereo

 

Try to clean my engine bay...TRY

 

Lowered the 77. Took out 2.5 coils up front since that seemed to be the norm when throwing in 3" blocks out back. Definitely went down more than 3" in the front. Feels like I have about an inch, maybe 2 but probably not of travel before hitting frame with all bump stops removed. looks pretty good tho Oh and threw some black spray on the steelies while I had them off. Pics tomorrow when I think I might start a build thread.