What did u do to make the wheels fit up front? I bought some just like these but found out the hard way that the end of the hub hits the bore on the rim were it closes to the center cap

 

What did u do to make the wheels fit up front? I bought some just like these but found out the hard way that the end of the hub hits the bore on the rim were it closes to the center cap

 

if thats all then either run a small 3mm spacer or bore it out with a dremel. do it little at a time.

 

Yup bore it out with a dremel or run a spacers . Can even be done with a couple rat tail files .. Just little time and elbow grease

 

simply understanding offset can help you a lot.

 

Thanks for the ideas

 

I like what you did with the tailgate. Nice lines

 

did you happen to notice the RHD conversion?

 

Right! Id love to find a rhd clip for mine while the truck is still down.

 

Finally sucked it up and got out the grinder and hacked her down a few more inches. And I am loving how it sits now!!

This was the Hellux the day it got into Ohio:


This is how it sits as of right now:

 

Looks dope dude.

 

thank you, sir! =)

 

not to much "flush" but it's definitely low!

IMG_1140[1] by estgang1991, on Flickr

IMG_1146[1] by estgang1991, on Flickr

IMG_1143[1] by estgang1991, on Flickr

IMG_1148[1] by estgang1991, on Flickr

 

Instagram

 

exactly what did you cut?

 

is that a skin or custom tailgate piece??

looks really good'

 

Empire's truck is custom, his block is probably hand made LOL

 

greeting from australia..land of kangaroos and rhd vehicles
i got something that you all may enjoy having a look at
ill post pics tommoz

 

heres my ghetto lux from australia
-4 1/2" drop in the front
-6 1/2" drop in the rear
18x10 -15 all around
225/40/18 stretch

enjoy

 

pretty good looking truck, mate