Well, welcome again. I know the feeling of watching helplessly when something like your truck gets away from you. How bad is the damage to the...
Dual 480c's- $399 100% duty cycle @ 100psi, 3.53 cfm @ 0 psi. 39 amps @ 200 psi, and 1 minute 15 seconds fill from 165 to 200. Single Air...
Well, unfortunately, there isn't any way to test it other than to rule it out as the cause of the issue. Luckily they aren't expensive, and once...
If it is a fuel delivery issue, I would start by replacing the fuel filter. I believe it is located underneath the intake manifold on the...
What happened to Frank?
Are you talking about installing longer bolts and washers?
Thanks Man, That's what I had in mind, just like to see someone else has done it. Did it limit your turning radius at all?
Yes, I definitely have to be careful airing down, thinking about adding a set of flow controls. Also control for the rear fill, as the 1/2" lines...
The only factory leaf spring panhard combo I can think of is on the front of the Ford f250 and 350. Maybe some other large trucks too, but this...
Did you read the article from Minitruckin? That has some good info in it.
Yes. It is your decision, so think it out. It won't hurt my feelings either way, I'm just trying to alleviate some of the bad stigma associated...
Well, there isn't an exact measurement. It would depend on where the top of the bag sits on the upper mount. So, with the bag mounted to the...
Um. Pics? I've considered adding them to the front of mine, but frankly it rides pretty good. The Slam bags seem to have a decent amount of...
I second that. I've seen lots of "great" looking welds fail. And I really dislike turning wrenches. I'd just as soon have a pedal powered...
When I measured, 3/4" would just make the pan touch the engine crossmember, this could be sectioned though...
What is all the plumbing for?
I have noticed that they have gotten a little better. I laughed when the NY'er guy launched the Caddy over the dirtbike jump and folded it in...
If you lower the engine via mounts, you will hit the pan on the center steering connecting rod. As far as I know, when you've gone this far, your...
Yeah, the nut might have a washer on it, but attached to it. It should come off with the nut. Then wiggle it....
Or when you push the brakes? Could be a vacuum leak. Usually the idle speed doesn't just change itself....
Separate names with a comma.
