Could be a vacuum leak. Mine had been doing something similar, finally found a split line, replaced it and it's gone...
But I'd still look underneath for the mower deck...:p
My manifold gasket went bad slowly and gave me a pestering tick. In between the manifold and the head. Changed it and it's gone...
Can you post more pics of the sides and backside? It looks really good, now you've got me wondering.....
Well, it's pressed onto the axle shaft. There's a C clip that holds it into place. But to get there, you have to disconnect the brake line to...
You can also get a bolt on box I believe.
Mine is under the bed on the opposite side of the chassis from the gas tank. I used a weld on battery box from Summit. I used 1/0 welding cable...
I prefer the stock valance on that bumper. If you like the valance, you could use the bumper that matches the valance, they look pretty good on...
Well, the next thing to do would be to visit a scrapyard and pull all the stock parts that you need. Is it 2wd or 4wd?
The fact that the noise doesn't change whether in gear, neutral, or braking rules out the u joint in my mind. I've had my share of bad u joints...
Jack up the rear end, and with it in gear or park, spin the wheels. If it's the wheel bearings or carrier bearings, you'll feel it.
Did you check underneath to see if someone had installed a PTO and a belly mower?
I have lots of pics of it... I've posted some up here before, I'll look and see if I can find them. Don't want to thread jack though.
Yeah, you'll be ok. You're only talking an inch or less right?
This is only accurate if you use the exact same tires that came on the vehicle. While I am not advocating overinflation, the actual pressure...
So many clean interiors... awesome.
Yeah. I'd say that's about as good as I've ever heard of one of these getting. I get around 24 MPG or so with my 22RE.
Yes, that may be true, but my original design allowed no offset on the caliper stand. I'll bet that there are lots more ways to accomplish this...
"84-88" only?:o
Thats pretty nice looking.
Separate names with a comma.
