Do you have the 22R (carburetor) or the 22RE (fuel injected) ? The 22RE has no carburetor.
This is a good source for Toyota motorhomes for sale. http://classifieds.toyotamotorhome.org/
Stay away from the 5 lug axle. Major recall due to axle shafts breaking. You want the 6 lug ff axle. They were pretty much standard from 1986 and...
OK, great. Now you have two doors which you have no idea what they fit. This makes perfect sense to me now.
I'm confused. The N10 is a first generation truck (1968-72). There were no 4WD drive trucks then. The side window vent must be an early model as...
In 1979 the body size changed. If your doors are from a 1978 or earlier, they will not work on 1979 +. If you have 4 headlights your '78 and...
Is that factory air conditioning I see? Very cool (no pun intended).
At least with these old vehicles troubleshooting is pretty easy. Imagine if you had to deal with computers, sensors etc. Keep us posted on your...
Sounds like a timing issue. Pull your distributor cap and watch the rotor as you crank the engine. It should be turning. If not you may have a...
W50's were prone to breaking. Parts are hard to find. Had a friend bolt a G54 out of an 1988 truck into his 1978 motor home. He said it was almost...
If your looking for a GO82 (1 ton, 8") they were used on Toyota motorhomes and c&c for places like u-haul box trucks. The 8" 6 lug off a regular...
If the coolant is boiling out that usually suggests the thermostat is not opening or not opening 100%. There is no such thing as a "fail safe"...
Just for fun , remove the thermostat. Put everything back together and run the engine until it gets to operating temperature. Replace the...
Have you got the correct thermostat? Did you "burp" any air bubbles out of the system when you changed the water pump? I've found over time if you...
I agree. What if you only want to change the front crank oil seal? Which brings us to the question how do you retorque the crank pulley bolt to...
After this I'm done. Did you read perkolaters comment about using this method? Definitely use a 6pt socket, not a 12pt. Also make sure to use a...
Pulley To Crankshaft 80 Ft-Lbs 960 In-Lbs 108.47 N-m Years: All Note: 5S-FE Crankshaft Pulley to...
Your beating a "dead horse". The method has been well covered here. Let the reader decide if they want to take the chance.
I'm lost here. If the head is off, what is the upper chain attached to? As far as torque spec's, the only # I quoted was 80-90 ft. lbs on the 20R...
I never said this method won't work. What I said was every time you do this you run the risk of damaging the timing chain. Whatever torque is...
Separate names with a comma.
