You could also install a set of 2" drop spindles...
That is correct. I just deleted two posts by a new user and banned this username. Hopefully I didn't do it to someone innocent, but none of my...
Yeah, I don't think that rolling will buy you that much room without looking hideous.
The minor diameter of the axle shafts are bigger than a dana 44 and smaller than a dana 60. If you use the 4 pinion third member and chromoly...
Sounds like there's a bit of air left in the lines...
You don't have to drill at all. There is a single hole centered in each hinge just big enough for a speaker wire wrapped in split loom.
I've been using the 1/2" Danz valves on my daily. Over two years now, and no hangups except for ice in the line, but that wasn't the valve's...
For some of us, it'd be a shorter list of unmodified parts...;)
All right guys, reign it in.
You could also run a hydraulic ebrake.
Um, I may be wrong here, but I've never seen a cast iron carrier. I've welded up a lot of spiders over the years, and they've all been cast...
Can't go super far into the frame rails because of the height of the diff. It'll hit before you go too far...
I have those A-arms! You'll like them a lot. I recommend getting a good primer and paint on them though, it's a pain to go back and paint them...
It all depends on the shock specifically. Some can be mounted upside down, some can't. If they are mounted upside down and they shouldn't be, it...
Not the best pics, and kinda old but here goes.... [IMG] [IMG] [IMG] If you want any others, I can get them. Just haven't taken...
Just a thought. Why stick with the zero offset? Do you have a specific set of wheels that can't be replaced? Seems to me that narrowing the...
Wait, is it cheating if I reply and then delete the thread?
Riiiiigghht...
Hey Bernie, how far do they extend into the fender area?
His point exactly.
Separate names with a comma.
