I know this is an old thread but did you check your shifter interlock? Many times when people do fluid changes they remove the wrong plug to drain...
No. But I love the full steel bed with the headache rack. Probably cost $$$$$ to get it shipped to the U.S.
http://www.ptcthailand.com/catalogue/panelparts/TOYOTA%20-%20Body%20&%20Panel%205.pdf No floor pans, but some cool body parts.
I’m running a Weber 32/36 with stock pump. No problems. Biggest issue I had was getting a good vacuum seal using the two piece manifold adapter...
Is your factory fuel pump electrical (in the tank) or manual? If in the tank you don’t really need a FPR as output is set by the pump itself....
Add a length of heater hose to the nipple in your picture. Loop it up and around your accelerator linkage then attach to the long pipe that leads...
It’s your engine. Before blocking off that return line you should look at the coolant flow diagram for the 20R. A quick explanation for why you...
Your truck was never designed for front discs. What you need is a proportioning valve to allow different pressures to the front and rear brakes....
OK. I tried to upload pictures but my file is “too big”. I did the Weber 32/36 conversion from Weber Carbs Direct. Based on your picture, the...
Your oil pressure sender acts as an intermediary ground for your fuel pump. You should have a yellow with black stripe wire(single wire) with a...
Check your alternator belt. Be sure it’s tight enough.
Not sure if they used thermo links that early. A melted one would keep your headlights from working.
W58 is an easy swap. If you source a W50 (hard to find), be sure it includes the shifter. Shifter alone is impossible to find and is unit specific...
If you’re talking about the seal on the axle shaft(s) you better plan on buying new bearing(s) as well. There’s no way to replace the seal(s)...
Try marlin crawler. They have 2 different sizes. I ordered both and used the one that fit (don’t remember exact one).
Before assuming it’s the cable check your accelerator pedal for sticking. Happened on my truck. A little lubricant on the hinge could solve your...
Check your oil filter for tightness.
The front crank seal is the same as being “almost pregnant “.When they go, you’ll be dumping almost a quart of oil every 10 minutes. Most common...
I doubt you will find a NOS wiring harness. Your options are to go to a salvage yard (good luck with that) and get a replacement harness or...
W58 is almost exact replacement for the L43. Should work fine.
Separate names with a comma.
