Only if you buy them through DUI. The components are all GM. Any 4 cylinder GM car that uses HEI ignition the spark plug wires will work. Ex....
It’s tough to diagnose ignition problems when you have a hodgepodge of non factory parts. If you have the original coil, igniter and distributor...
It’s been awhile since I changed my pump, so bear with me. If I understand you correctly, your new pump motor runs when you attach the pigtails to...
Not sure what you mean by “fuel sending unit”. You may have a problem with the supply wire from the switch to the pump. Worst case, find an...
Dif should be 1.6 qts. Manual transmission 4speed 2.0 qts. 5 speed 2.7 qts.
Your fuel pump will only run with the ignition in the “start” position(if the engine isn’t already running). Simply turning the key to “on” will...
I run mobil 1 in everything. 15-50 for the engine, 75-90 for the transmission and 90-140 for the differential. Been using it for years now. Very...
One of the tricks I use to save money is to use Rock Auto data base and interchange numbers. Then search the part number on Amazon. With prime and...
Why spend $200 for an old dated carb. Add another $100 and get a Weber redline 32/36. You can get them smog legal and even with water choke if...
If you’re pulling the water pump best to change the crank oil seal at the same time. These are known to fail on a regular basis. 20R and 22R.
What type of engine? Need more specifics before even trying to take a guess.
Weird thing is it’s factory original. Line & location. Could be over time the inner fender dropped a little causing the wear. I relocated the new...
Thought I’d throw this out there for consideration. I suddenly had my brake pedal go soft while driving. Pulled over and checked the front...
Forgot to add the basics. Double check your battery top posts. You should not be able to rotate them in either direction once tightened. If they...
Check your contacts at the starter. Clean everything up with sandpaper or wire brush. Starters need a good ground to work correctly. Also check...
Not sure which transmission this is but looks really clean. Don’t think the axle will work for anyone. Just thought I’d pass it on.
I think it’s M8x1.25. Could be M10x1.25. It’s been so long I’m not sure. The pitch is definitely 1.25
Your exhaust manifold is held on by a combination of bolts and nuts(studs). I replaced all bolts with studs and nuts. This allows you to use...
Not sure I would try brazing. That puts a lot of localized heat in one area. Talk to a weld shop. They will know what will work best. You could...
Your manifold can be repaired using a stick welder with nickel rod. MIG will also work but the weld won’t be as strong. Due to the high carbon...
Separate names with a comma.
