The bolt has a 1.25 pitch. Any decent size hardware store should carry them. It’s either M8 or M10 x 1.25. Can’t remember which it is. Also, be...
The thread pitch is 1.25.
I have a transition model Toyota. It’s a 1979 with 1978 Toyota mechanicals (4 headlights). Rock auto shows 2 different Cardon numbers depending on...
On my truck the glass channel has a fabric seal rather than rubber. The way it’s supposed to work is the seal grabs the glass by friction and...
If the truck starts and runs fine it’s probably not the oil pressure sender. If you have the intank fuel pump the fuel pump relay is tied into the...
I’ve got the 20R. Every metric bolt and nut I’ve come in contact has the 1.25 thread pitch. Cylinder head, block, accessory brackets etc.
My M8 & M10 are all 1.25. Maybe they used a different thread pitch on your truck. Mine is a 1978.
Most all metric thread pitch on these old Toyota’s is 1.25.
[ATTACH] You should have an ID plate under the hood that gives you engine, trans, rear axle and paint code. Attached is from my 1978. In my case...
If the moisture is just on the lower section of the door panel you might want to make sure the drain holes at the bottom of the door are not...
[ATTACH] You’re getting fuel. I’m guessing your timing is roughly where it should be. The only thing left is your distributor and coil/igniter....
You mentioned changing out the coil. Did you also change out the igniter? or are you still using the one that was fried? If you’re still using the...
Makes sense. Must be a European thing. RHD.
None of my source references say what the passenger side dash blank is used for. It could be a European or overseas item as Toyota sold these...
Your igniter is a very delicate piece of equipment. It basically controls your entire start and run process. Just because you got spark now,...
Looks like your igniter is shot. Very expensive to replace. Try to find a good used unit. New can run $250.00
Check the tension on your fan belt, it could be slipping. If not, I second Pearce. Alternator or voltage regulator.
[ATTACH] Be careful on which side of the distributor you power from. You could damage your electronic ignition. Old school says attach the (+)...
No. You would have to calibrate the float to the tank and run new wires for the gage.
Hope it works for you. I’ve never heard of high vs low profile VR. 1978 did not have a VIN but a chassis ID number. Post your results when you get...
Separate names with a comma.
