7" wider than what gen rear axle? Mine is 53" wide. Have a project in mind that will need something around 60" or so.
Lots of people have. These days it's hard to justify the cost not bagging it. And most peeps are on the cheap lol
The thing with giant flaps is they will drag away quickly. And the wider part would make them catch alot walking past them. If you do put any...
I gave my original flaps to my old boss. At the time I thought they were dumb. I sure like having drag flaps now though. I've ground the tips off...
Summary, run the 81 booster and master. Of you upgrade the brakes, use a 4 bolt master with the right ratio for the bigger fluid demand. Good luck...
Basically you made your frame rails to bolt in the supra subframe? I always thought that was a great route. What's the width brake to brake? I...
I've been steering more and more towards hydros for my project. My 78 is about as low as static will allow. With hydros there's no noisy...
For coil overs you would need a link bar setup. A 2 link at minimum. Mounting the coil over is as easy as having a frame and axle mount. The stock...
I always liked those tC wheels. Looks good buddy
Well you should be set. IF you go lower in the rear, you may eventually have to hammer the trans tunnel pinch weld at the back can wall. They rub...
I run an 81 booster and master on my 78. Went hunting at the junkyard one day and found one that looks brand new. So I replaced my leaky large 78...
It's a good start. You'll probably get the itch to go lower later. If you have a long bed, the carrier bearing crossmember will be your worst...
Once some other guys chime in they will have more info. You may be able to make that rim work tho depending on the offset. Unless you're bored...
For an 18 you'll probably want a 205/35/18 or something similar up front. I have 17x7.5"s up front. Lotta low guys run wide rims. These...
So then it's an issue of too much space under the truck. Shouldn't be any room to see any light that's behind the truck :ROFL: If you don't...
I think turning aired out will vary truck to truck based on fenders and wheels they ran. But, I am damn close to laying frame static and I have...
You either have underglow lights or too much frame gap. It's all lit up under the truck lol
Finish...I can't tell if you started lowering it yet :lol:
Who need cam sensors. Ill take an electronic dizzy for the win. Lol
Ill do bearings when I do late model brakes. I have other problems to chase down before I get to preventive stuff.
Separate names with a comma.
