What exactly is the difference between a "powerful boom" and a "profound low boom"? Are those technical terms? The science of audio reproduction...
When it comes down to it, the driver is only about 10% of the whole driver/enclosure combination. The JBL had the best excursion numbers, but...
Nam, have you seen my 10" enclosure under the rear seat? There's just under a cubic foot of volume there, so a 12" would be possible with the...
If you look, the notch is right under the bed floor frame. If you didn't notch it as much, you could gain quite a bit, how low do you plan to...
Awesome. Welcome to the TM.
And it looks amazing. :bow::bow::bow::bow::bow::bow::bow::bow::bow::bow:
Bernie? He did a great job with the Lolux.
Ok, how does a tire manufacturer measure tire width?
Hmm. So this is how every manufacturer does it?
These are the same people who claimed that Bush didn't have enough proof to go into Iraq. Now they don't have proof, but its necessary that we...
If you have a 9" wide wheel with 4.5" backspacing, it should be a 0 offset wheel. Wheel width minus backspacing equals offset. Have to convert...
My Miller. I've been using it for 6 or 7 years now. Wouldn't mind getting a big window unit, but can't justify the cost.... It still works...
You definitely don't.
My truck is my daily. Can't stress that enough. It has little rock chips and scratches from all the abuse I put it through. Because I used...
Nope. Mine was a good 4runner.
Hmm. Can't remember off hand. Either a 19, 21, or a 24. I should know this, I've built enough of them over the years.
A simple replacement one will work. I personally stay clear of the newer plastic tanked models, but they do work.
No, it should be tight and punched into the groove running through the threads parallel to the length of the pinion.
Have you done the urethane bushings already?
Ordered the Turbonetics T3 Super 60 today. With a .48 AR turbine, it should spool a bit quicker than the .63 AR T3/T4 thats on it now. After...
Separate names with a comma.
