Sounds like a fun project. I have lots of little dash switches and small parts. Got plenty of stuff. I want one of those vintage license plates...
Maybe its time to start rounding up parts for a stock shift swap. Not sure if that suits your needs, but most of us prefer them on this type of...
Not today, but yesterday I got my sliding around real nice on the valley roads. Sure is nice having my 17s back on. The new fuel pump works good...
I have a header too. Lol. It's been there for almost the whole time I've owned it. You just got your truck. You can keep copying me. I don't get...
What's the center diameter? eBay has universals by diameter. I've run them on stockers before.
Pop ups are fun. My old one could pop out too. Let me know a price when you find one. I'm always keeping my options open.
Copycats :lol:
I had the similar design wheel from an 80s crown Vic/grand Marquis on my 84. Looked sweet. I say do it.
Sweet deal. A 205/50 225/50 combo would fit great for tires.
I see alot of RHD hilux surfs (4runner) in Canada. May check there yards and craigslists for parts.
The basic bolt ons would be a header and exhaust system. That can carry over to any engine. The stock internals are fine for most cases. And a...
Welcome bud.
The w series trans are tough but not bomb proof. I've toasted a couple and beat up a lot. Don't downshift from 2nd to 1st to slow down for red...
I've had to do my clutch once and decided to just pull the motor and trans together and swap it on the ground. Turnkey to turnkey was about 3...
So it runs strong now. New fuel pump and strainer did the trick. Didn't get any rolling bed stunt videos lol. Cuz the tires I swapped on suck. I'm...
Yup. I always kick my exhausts out in front of the back tire. Not just toyotas, pretty much every exhaust I make.
Mine will snap to 130 pretty quick. My gearing keeps it from going faster lol.
Here's a view showing the exhaust. It's a chamber muffler with a full 2.5" system from the header-collector back. I used 2 45* bends instead of a...
Here's a few underside pics. I built my own 4.5" blocks from two broken sets of DJM 4" blocks. They share a common center pin bolt all the way...
It's still running, just can't support any fuel demand past about 5 mph. Ill back under it tomorrow after a few test drives around the block to...
Separate names with a comma.
