Unless your trans is howling like a banshee or grinding in 5th gear there is nothing wrong with your trans. Its simply a lack of power coming...
Minor update since I finally had a few minutes to work on the truck. :D I needed a heat sink for the msd HEI module. After a bunch of ideas...
Must have been. :ROFL:
I have no problem with a bit of stretch at all. I actually prefer it in some cases. I've ran 195/50, 205/50 and my new race front tires are...
What? http://youtu.be/29g386hXwyI Opinion or not reducing the contact patch decreases the vehicles performance to negligible levels....
Dare to be different but don't get butt hurt when people make fun of what you're doing. 1* is nothing, most of the stupidity in that video was...
Uh yea, I'm still in 3rd when I'm doing 45. :lol: The owners manual recommendations aren't worth the paper they're printed on.
Welcome to the world of 4 cylinders and 4 wheel drive. The problem is you're trying to use 5th before you are doing 70. :lol: The last...
I keep thinking I need to put the welded 4.10's back in and slap the old bias scat tracs on it. Smoky drifter truck! :lol:
I ran 195/60/15 all around my first autocross event. They were a softer tire than what I have on now though so they worked pretty well. I...
Just ordered up a pair only tires for the front of the truck. The all seasons up front are 420 tread wear and the rears are 380. The rears are...
Could've? "Hey guys my truck is sitting crooked and it pulls hard to the right, what could be the problem? " [insert several intelligent...
On level ground jack the front tires off the ground by then center of the cross member under their engine and see if it levels out. Rinse and...
Not to forget that the trans vents through the shifter housing so there has to be a channel of some sort.
Sounds like the ground harness isn't bolted down. There should be a small bundle of brown wires with black stripes that bolt to the lower part of...
Toyota transfer cases and axle fill & drain plugs are all the same thread pitch & size. I like to use t case fill plugs since they have a nice...
I don't even consider 2" as being lowered. :lol: Just need to be mindful of debris in the road and some entrances/exits to businesses and of...
[IMG] $20 unit from speedwaymotors.com welded to the shaft. Not beautiful but it was cheap and effective. :lol:
I plumbed my whole wheeler with 1/8" steel line. Its a little smaller than the metric line but I didn't have any leaks. The fittings are...
I wouldn't doubt that the guts are in fact interchangeable. Call marlin of marlincrawler.com I'm sure he'd know and likely have a source for...
Separate names with a comma.
