Pull the bed (can easily be pulled by yourself) then jack and block the cab until it'll clear the rear tires with boards under the cab supported...
Right just like every other rig of that body style. The sr5 runner just has a light pointed at the ignition otherwise it's the same.
Yup it has the light for the ignition switch. I know I have one good vent on hand but I'll check this weekend if I have the other 3 you need.
I've got seat x cab belts and an sr5 runner lighted tilt cover in gray. I've probably got the vents too if you want to do some one stop shopping....
Sorry for the delay, it's a 1981 national seal. Oriellys had them in stock when I needed them. My trans had the same bad bushing. I found a...
I've used them before and my results varied from the rig running a bit warmer to a noticeable drop in power. I couldn't run one if I wanted to...
That flex fan is going to do nothing but rob power. You'd be ahead to run the stock fan since it's not under power unless needed. It isn't as...
As requested. [IMG]
Post 1983 it's pretty basic. G40 is the common 4 speed 2 wheel drive trans. W55 is the common 5 speed 2 wheel drive trans. Carb'd 4 wheel drive...
Yes it's a direct fit. All aluminum W series and all G series have interchangeable bell housings.
I'd swap the input and output seals while you have it out. I have the input seal part number at the shop I work in but the output is the same as...
G code 8" is the only one worth swapping in my opinion. Mega aftermarket, gearing choices from 3.43 to 4.88 from the factory, limited slips and...
Well you're in luck since I'll be pulling the trans this weekend. :lol:
The senders don't matter. Remove one style, install the other in its place. A 4 speed tail housing won't fit on a 5 speed trans. 5th gear is in...
In desert racing, monster trucks and a few other motor sports they match sway bars. IE if the front t bar is mounted in front of the axle then...
Necessary for the current drive train, not really. For the wet dream LS1/T56 yes it will be needed. Running an 18 mm rear sway bar isn't enough...
I haven't stiffened the chassis yet . I do have a cage bent up for the truck but I'm having second thoughts since it is only 1 1/2x.120" DOM....
Fancy install under the dash. :ROFL: [IMG] I reused the stock wiring to the distributor and even the stock bracket to hold it onto the...
I think he missed your location. Down here we can do as he describes. The insurance company cuts us a check and we get it fixed or if it's a...
It's all hooked up and running. I had an old dead ignitor so I robbed the plugs off of it so if something happens to the new ignition it's a...
Separate names with a comma.
