What are the points gapped at? Or did you replace them since last that it ran? Have you advanced the distributor or retarded it to see if it helps?
What direction is it back firing? Out the carb or the tailpipe?
If it's far enough out of whack that it interferes with the air filter then it isn't set right anyway. ;)
Coolant line... As in the small lines going to the choke assembly? If so just loosen the center bolt and rotate it out of the way.
Everything about nascar rigs is custom so yes. I stopped watching nascar when they stopped being actual cars and went to a template body.
You answered a question that wasn't asked. He's looking for a deep sounding exhaust note and the deepest I've heard on an r series is hands down a...
Welded MagnaFlow. [/thread]
Nascar runs splines cut in a diamond shape to allow for camber and toe so the cars handle well at high speed.
84-88 springs are pretty much the same between 2x and 4x. 89-95 is when they built the 4x springs differently. They are different lengths so the...
A guy on another forum I'm on tweaked the housing on his old ae86 autocross car to have 1.5* camber per side. Said it was hell on tires but it...
Yup. Could also raise the spring and shackle mounts into the frame.
3-4 are the same fork. This leads me to lean towards the shifter seat especially since it appears to have a shortened throw. I'm thinking the...
You have a new clutch and shifter seat installed or are you asking if you should install the parts? If the latter yes, you should install the...
1. Nope as stated it's aluminum. 2. See post 12 in this thread. There is a vacuum port with 3 lines coming off of it. Plug one, use one...
That's an easy one to helicoil or simply tap deeper if there is meat down deeper. I should be available Sunday evening to check it out for you.
Not that it makes a difference at this point but it's an 84 not 88....
Stop reading words that aren't there, I didn't advise anyone in this thread to remove anything. I made a joke. ;) Even if I had its a little...
Done waste your time with the stock trans. I've looked into it a good bit since its a common engine and trans package to grab out of a wrecked...
$3000 will cover the parts OR the labor to have a shop do a custom engine swap. My suggestion is to build a mild 22r with a light flywheel, swap...
And now we get down to brass tacks. I don't care about fuel mileage on this truck. Not a bit. It isn't built to turn 50 mpg it's built to put a...
Separate names with a comma.
