I would hide the door popper on the bottom side of the door so if it does get cold out you can open the door from the bottom. No one would see it...
I am getting excited. I should be able to have the truck on the road in a month and in a few months painted.
Check this rear bag setup, this is some amazing fabrication. 1993 Toyota Pickup Custom Chassis Photo 9
So i spent all weekend trying to remove the crappy paint off my new rims. I found out that they still had the stock paint and primer then someone...
Yeah I am guessing I will bottom out a lot. I think i will keep the 4 in until i can get it notched then i will pull a leaf and see how it sits. I...
I measured it and i have just over a 6 inch gap between the axle and the frame. I figured i would do a really low profile bump stop and pull the...
Nice truck, looks like a fun project. I struggled between buying a half modified truck or a bone stock. I went with a bone stock one and hasnt...
I started removing the paint last from my rims to start polishing them down last night. I will post some pictures on my thread later today or...
Should i do 4 inch angled blocks then take the truck to do a half notch? I am sure it would be fine to drive it to where i would need to go for...
Would a 4 inch angle and a middle leaf pulled fit with out notching my truck? I want to notch it but not until i can actually have it drive able.
Wow they are spendy, I will stick to belltech or jdm for now.
I do not see angled 3" blocks. Would it be smart to do a 4" angled block? Is steel or aluminum better?
Do you want to sell them?
Ok i bought the spindles from there already but i can not find any lowering blocks. I would like to get some angled ones. Any ideas or brands?
I want to order these this morning to ensure it ships today. any help?
I am trying to order so drop spindles and a some lowering blocks. Where is a good place to pick them up and what model of drop spindles do I need?...
Wow i cant believe that. I wonder why he would lie about it.
What is it like mounting a 2rz or 3rz motor in a 89-94 pickup? Can you find motor mounts for it?
Yeah i was surprised to see that they did not fit. They fit now and have no problem pulling out a grinder for something like this. I probably...
I did get a set of the black altezza ones and i did have to grind the bottom mounting bracket a sliver to get it to fit. I have tested the...
Separate names with a comma.
