I believe some guys ran 16inch rims... but am not sure... I know from personal experience 17's are good for sure... I got mine for a steal on...
I think it is pretty much and even trade... but as far as working on it and parts... keeping the yota is a better move now if it was this one...
if your going to bother upgrading do a bigger brake kit. I still have some adapters left to run wilwood 12.19 rotors, and 4wd 4 piston brake...
They are about $150-$175 new and these as far as I know are discontinued... Make an offer....
Got a set of grey toyota q-forms... came in my 93 when I got it in 03... I took them out and they have been sitting for 5+ years now... I knew...
3 pairs sold 7 left
I am pretty sure I have the gray knobs and lever... somewhere... PM me an offer.... Just as FYI I used a window crank for the lumbar on one...
Received the caliper stands today... $75 shipped a pair.... paypal [email protected]....
Their coming! Got notice today the next batch of caliper stands have shipped! Will let everyone know when they arrive!!!
I sent back a set of chassis tech I got off ebay a couple years back, they were junk. I think the belltech is a much better spindle. blocks are...
I need to know the distance from the center of a front spindle 84-95 to the caliper mounting point.... Any ideas where I might get this...
Due to lack of time and the answer to 1 question.... I had another set run since I regularly get requests for more of these. If anyone can tell...
I got an update from the machine shop. It should be no problem selling this order of stands for $75 shipped. I have ten pairs coming, and about...
Same design....
No problem for me... If you find the right rotor... or a site that lists rotor dimensions... let us know. I will gladly sell you a pair of...
You would need to find one... it would have to have a shallow hat offset that places the rotor about 2 inches behind the hub face. They would...
if your truck came with a bench then the inner rail rear bolt is where your seat belts are bolted down now. The bucket seat trucks/runners have...
Check out this page and you should be able to figure out your tranny... http://www.brian894x4.com/Gearratiosanddiffs.html The shifter comes...
the rotor hat thickness is added to the track width, about 6-10mm total 3-5 each side... minimal.... I run a 17x8 with 12mm offset and have plenty...
Take a 17mm, 15mm, 14mm,12mm and a 10mm and your fine... I would bring an extention or two and a breaker bar.... the caliper bolts are 17mm I...
Separate names with a comma.
