Yes she does, & thanks.
Coverage is up https://www.built2rail.com/2019-mini-truck-showdown/ This show was great, for time show & bad weather, still 200 showing trucks &...
Anyone one on this site going to this event?? If so stop by & say hi. This is a first time show & expectations are high that this will turn into...
Will be metric, pick up a thread pitch gauge
First show for 2019 is in 3 weeks, & been very busy readying my truck. Got the new air management system in ,though the height sensors still need...
I ordered molded carpet from some one years back, not sure who , it fit fine.
So finished the height sensor install at the front, still have to run the wires & calibrate & test drive. While working up there found one air bag...
Today got the rear done, figured out that the range of travel was to tight so moved the sensor future rearward. That put the arm into the green !...
So started the install of the height sensors, made a tool to get accurate measures of travel & to locate the mounting tabs. Working at rear first....
Thanks
Got all the fame & suspension parts repainted in gloss black & the manifold mount finalized. stuck the front part of the console in place to test...
California Car Cover, should or can make what you need. I have one for my 88 which is a full custom ride ,stays in the garage ,but stays outside...
The W58 I bought was $850 ,I paid $800, as drove to get it , while researching for one seems a lot were $1000 & up. A completely rebuilt tans from...
I have the W55 ( manual 5 speed) out of my 88 Extra Cab, works & shifts fine,remove & swapped out for a W58 because of a noise in 5th gear . Had...
[ATTACH] Merry Christmas Too All
Just replace the whole unit so not the damage anything else!
Got all the air lines run & the mock completed. Now reweild the battery hold downs & run the wiring ,than make the mounting plate out of...
Only one inlet feed, manifold has 5 feeds, LF/RF/LR/RR/T/E, but will use a tee from the 2 hard ines from the tanks. This manifold does make for...
Today got the soft lines pulled to the rear, & made a mock mounting plate for the manifold. Had to change the way it mounts, angled is what I...
Well got all the soft lines ,two hard line, valves & all the wiring removed. Retied (zip ties) the wiring that stays , & will cut off the front...
Separate names with a comma.
