Today, I clean out my storage shed. Loaded up the truck with as much scrap metal as I could and dropped the scrap off at Recycling. Made 2 trips...
Eww....thanks for tip. I'll check it out..I.d **** myself if a critter popped out of the dash while driving.
Started her up after 3-4 months of just sitting. She started right up but for some reason the interior smelled like cat piss! Still took her out...
LOL I have been thinking the same thing for years but I think I'd have more success with " FA-Q".
Those air shocks are nice. I have a set of hijacker air shocks on my dropped rwd corolla wagon. I had installed an onboard aircompressor from a...
Not trying to discourage you from completing this turbo project but you would have much more precise fuel control by swapping in the efi setup...
The standard wheels are as follows: 1) 16x7 +18 offset 2) 16x8 -10 offset Then there are the rare, expensive Special Handling Package...
77yoter, That electronic speed sensor must be from a 88-92 supra with the w58. The w58 from a celica would only have a mechanical setup.
Nice truck. I was thinking about painting the center of my starion wheels and this pic sealed the deal. [img] The red and black goes...
Yeah, that's true but I am going to cut the wheels arch on the bed and install a set of 4runner bed flares from Hanneman fiberglass. [IMG]...
Hey Frizno. The motor has been holding up remarkably well. Especially since I am running the ecu from an early celica (83-84). It's a naturally...
So, I felt that my truck could use some toughening up. I decided to add something that would make it look more menacing. [IMG] [IMG]...
Check MCmaster-carr out and search "LATCHES". Many to chose from. I was going to buy a set until I found some latches in the J/Y. Link below....
Keep in mind, the power ratings listed for the 22RET are at 5-6 psi. When initially drove my 87 with a 22ret swap at stock boost (6 psi) it did...
You guys give me alot of inspiration. Especially when I see the chassis fabrication you guys undertake. I also love the fact that there is...
My 87 truck has the flat sided jap bed and 2wd front fenders. I am running starion 16x9 - 0 offset wheels with 225/50 tires on the front. After...
If the oil pan is still off, wedge a piece of WOOD between one of the rods and the block girdle. You could use a steel bar as a wedge IF YOU ARE...
Like everyone else said. If you dont have the skills to do a cab swap, there is now way you will be able to repair what you have there. It's...
The suspension only had 3 inch lowering blocks (one was cracked) in the rear and cranked down torsion bars. I am not building this for drifting....
Nice work man. I'd like to see this in person.
Separate names with a comma.
