If the only thing you changed was the preload on the trans mount from pre vibration to now then yes that would be a solid guess as to the culprit.
A header made for a 85 and earlier 4x4 will be very close to the torsion bar on a 2x4 from 79-95 and depending on manufacturer may not go back far...
I've used brake cleaner before sure. I've since strayed away from its usage if I'm going to be welding on the material. Safety Alert! Brake...
Hose it down with a good degreaser like purple power or super clean to get the grease off them spray the ring gear and pinion with spatter spray...
Not all 2wd were 7.5". Odds are if the truck had efi and/or a 5 speed trans yes it probably has a 7.5" diff but 4 speed trucks normally got the g...
Yup my rigs get abused until I finally take off anything good and scrap the leftovers more often than not. :lol:
Meh not all toyota trucks even came with the adjustable valve. Some had either a proportioning valve mounted under the master cylinder or no...
Yes.
Or just grab a hold of the rod and yank down so it over cams and stays in the low position. :lol: [IMG] The valve really doesn't make that much...
Turbo model brake vacuum booster from 86 or 87. The later IFS era axles are the same strength for the most part but the brakes are a good bit...
Direct bolt in if the other rear axle is a G code. Easiest way to tell at a glance is to look at the drain plug on the housing. If it's on the...
Pretty much the typical leak and odd rattle check will get it sorted out well enough. If it sounds like a sewing machine tapping along at idle...
Yes you'll have to upgrade the master and I highly recommend going to the turbo booster and swapping in braided brake lines at the same time. If...
76ish fj40 rotors and either 86-92 4 cylinder or 88-95 V6 calipers. Either caliper will bolt on in place of the stockers but the V6 calipers will...
Sick build so far. I'm going to guess you're going to run some desert style flared fenders and bed sides with that tire size and wheel backspace?...
Lose the points and be done with it once and for all. A later model distributor will drop in then either find a factory coil and ignitor or set...
4x4's with radius arm front suspension will get violent axle breaking hop when spinning. It takes a very stiff shock to keep it in check so the...
8 months and could time now. Too bad it wasn't on someone else's insurance. Here you could have them get you a rental car until your rig is...
I wish I'd have had the cash to buy your 8" supra lsd when uou had it up for sale. :duh: now I can't find one for anything under $250. :brickknock:
Finally had time to work on the exhaust. I loosened the header and slipped a bolt between it and the torsion bar. I now have about 1/4"...
Separate names with a comma.
