So after all that i opened it up and the chain looked new. Guides were still there and in tact. Chain was tight. No slack. I dunno what the...
I been thinking this idea through as well, just never had a chance to measure out the leafs. I think its almost a direct swap too. I was...
Thank you BYE. Will come in handy tomorrow and hopefully ill be able to pull the timing chain cover off.
Im working my way through mines now, and when i got my gaskets, the guy gave me a whole set. Apparently they have them boxed where theres all the...
No it wont mess up the gasket. From pulling off my pan you can undo all the bolts but the gasket/silicone will still be holding it in. Once you...
I picked up the gray. The guy told me they were all the same. The old silicone on my truck is the orangish one.
So yeah after all of that, do i really need to drop the oil pan? Right now its sitting on the steering components. But do i need to access...
Yes i went bacck out and tried a few more bolts and they all appear to be the same size and have that gray RTV **** on it so i assume its fine....
Good luck man. Im doing mines now as well. Can check out my thread couple down if anything. Been posting up pics and asking for advice along...
Try go hit up beefed taco. He can get get you blocks and some top notch u-bolts.
Ok running into a problem dropping the oil pan. I dropped the cross member and began taking out the oil pan bolts. The first 2 came out no...
Ok so after bitching and moaning i went back out and tried it again and finally got it off. Heres a picture of how i did it. Wrapped rope...
Dang, tried putting the belt back on but didnt realize that i unbolted the bolts for the bracket and there all different sizes so no matter how...
Thanks for the advice. just looked it up and looks like i gotta put the belt back on and i going try yank the pulley to reach the bolt. Thanks...
Yeah, cruddy bolts tend to let the wrench slide and round over the edge. Helpful tip for next time, make sure crud is cleaned off before...
Ok got that one off, thanks shade tree. Anyone got suggestions for getting to this bolt? I tried using a open end but it keeps slipping off. Is...
Thanks for the help flacostaco. Got the hub off. Anyone know about question 2 and removing the pulley? Ill try a bit more and get ready to...
Ok running into some problems. 1. I cannot get this hub off. The one the radiator fan attaches to. In the manual it says to unbolt it and it...
Build a hybird. Throw a 20r head on it.
I think the only time you need it decked is if you think its warped. If not no need to get it decked. You should also call around machine shops...
Separate names with a comma.
