My 1988 Reg cab has a knocking or clunk sound that comes from it when driving( turning wheel ). I have figured out that if I open the hood and...
These came out of a 95 4Runner. They were covered in upholstery plastic and are in like new condition. Local pick up only please in South...
Went to the junkyard today and found a set of Bucket seats in a 1995 4runner. I thought that they would bolt right into my 88 PU but the brackets...
Original grey pad had a small crack develop, tried patch repair a few times, didn't like it and crack slowly spread. Bought a dash cover,...
The Shifter from a 88 Carpeted floor console ? Is the rubber boot screwed on or does it have a lip ? Is carpet tucked in or screwed down ? I am...
I just bought another dash pad and I am going to try and recover it with maybe some grained vinyl ??? Has anyone ever done this ? any tips or...
Is there an adapter that you can buy to run a aftermarket air filter that does not cost a fortune ? I can get a LC Engineering one for about...
Got the new tires and put on my redone Turbos. Al that is left is tilt column and maybe some striping down the road. before [IMG] after...
Just got my 88 back from the paint shop. New base and clear coat and spray in liner. I know most of you guys prefer the slammed look, but I will...
Can the rubber mounts on the cab be replaced without removing the cab all the way ? Is it a hard job? Is it worth it as my bushings are 24 years...
Be honest and tell me what you think. Some before then after. [IMG] [IMG] [IMG]
Anyone chrome paint a grille ? Does the chrome rattle can stiff work well on our grilles ? I have that is stating to peel and was wanting to try...
I need one set of a bolt with two nuts if anybody has some lying around for a 84-88 PU. Let me clarify, I only need 1 bolt and two nuts not a...
I have started by removing the bed and using some rust extend on the bottom of the bed as well as a few spot on the chassis. Just a bit of surface...
I am in the process of removing the bed to clean and undercoat it. When I go back is there any upgrade type mounts (rubber cushion or bushing ) as...
Give em up !!! :ROFL: 22R88
Sweeeeet !! Toyota Toyota - eBay (item 251001116865 end time Feb-25-12 11:35:01 PST)
Anybody ever swap out a tilt from a non- tilt truck ? I got one today at the JY. Wondering if I need to swap it wholesale with the steering shaft...
Guys, I just put a SR5 cluster in my 1988 2WD DLX from a 1984 4x4. Everything works good after I recalibrated the tech, But I notice that when...
I just swapped out my original cluster for a SR5 one from a 1984 22R 4WD pickup. When I am idling I am at 800 RPMs, same as my aftermarket tach...
Separate names with a comma.
