While I appreciate the amount of time and sweat that went into that, that is one of the ugliest pieces of custom work I have ever seen.
I'm not sure, exactly. It's going to be made from 1.5" round tube and skinned with sheetmetal. I have some idea of what the main tube layout...
I will have one available after I get my engine rebuilt, around the end of June.
Yep!
I hope your machinist can find a way to do it clean. That would SUCK to have to disassemble it, have it cut, clean again, and reassemble! There...
The timing cover is supposed to be bolted to the block when it gets decked! It has to be the same height so the head will be able to sit down...
If you want to post pics, set up an account with flickr or photobucket or something. Then you can link to those.
Those are ram tails, right? I believe the Dakota tails are the same, only smaller. They would probably fit better.
Go to the pirate4x4.com forums and find the marlincrawler Formula Toy build. They are using an external inline fuel pump, from a celica I...
OMFG!!! That dude has to be the biggest retard ever! Even including Mike Tyson!
Need some help designing my new front bumper.
Actually, I have access to a mandrel tube bender. Custom bumper! :waytogo: That sucks! I have to do some sanding on one of the fenders and...
Good news and bad news for my build, today. The good news is I got my 4wd fenders and corners installed. Before...well, halfway anyway:...
Here is a link to somebody who had a mk2 supra LSD installed in his taco rearend. I think they use the same 7.5" differential as ours. I'll keep...
everything is the same. Just remove the four bolts that hold the bearing pocket, slide the whole assembly out, and install in the new axle.
Every one I've run across has been. Supposedly the 82-85 supra LSD carrier can be used. Not the whole third, just the carrier. Never seen a...
No problem. My lead fell through. It's an '88 bed. Nope. All trucks with a USA manufacture bed (some Canadian trucks may not) have the same...
There's a bigger gap in the front because the fender is 2" higher. And you're not dropping the rear more than the front. The rear gets more than...
NAPA usually carries them here but they were out. I had to go to a specialty automotive paint supply store. Rota Slipstreams. 12 lbs. each!
Yeah, they're my new favorite tool! Until the next one, anyway...
Separate names with a comma.
