ya, I will put together a build thread soon enough... just been busy/lazy lately
haha. i ended up just raising it up one notch until i can get a different suspension and do the usual bj flip and drop spindle mods.
a ball joint flip would fix this, but I can't do that on this older style suspension. I better go to the junkyards looking for a 84-88
just measured, about 4 1/2 inches
I guess I need to put a later model suspension on...
I lowered the front of my truck today and now when I turn right, the end of the Relay Rod hits the passenger side Strut Bar. I now have about a...
the torsion bar has splines on it. take the key off of the splines and rotate it a few notches. put it back on and tighten the key back down by...
yep, right behind the cab. I figure it will look original/goofy which is the look I am going for. And thanks for the replies!
Which would you suggest, and which model? Oh yeah, and I will probably be going with a smoke stack exhaust.
no tension?
i took the middle two out (3/4 Ton)
no .
i got mine from the dealership
I don't think it matters what type, as long as you get the ratio of water to coolant right.
I just realized that you are from Canada, so I am now going to assume you have had antifreeze in there. Just flush the system, refill with water,...
Did you only use water or did you put in antifreeze/coolant too? The PO of my truck put in a new radiator a couple years ago and only used water....
the smallest ones go on the top of your exhaust manifold for the EGR system. not sure about the other ones.
Separate names with a comma.
