Those year trucks were bad for air blockage in the heater cores, the heater inlet hoses sit higher than the radiator, raising the nose of the...
Should be able to take the shock out, swaybar end links loose, front brake line probably, compress the spring with compressor, and seperate the...
Thanks EFnetOper, Thats what I was thinking was the 4x4's had the dash mounted bypass switch and the 2wd didn't. but both have the clutch pedal...
I,ve had quite a few offers over the years to sell my 76, never could bring myself to do it even though the offers were good, but considering the...
When you guys say your base 2wd has it, are you meaning it has the clutch switch on the pedal or the dash mounted bypass switch? the earlier...
Heres an easier solution,,, Tachometer Tach Signal Interface SGI-8 Dakota Digital - eBay (item 390269556797 end time Mar-06-11 08:16:59 PST)
The stock tach can be used, it just needs to be recalibrated by adding the correct ohm resistor or an adjustable one into the tach wiring.
Most all newer manual trans rigs have a clutch start switch that requires the clutch be pushed in to start so it can't accidently be started in...
Thanks for the larger pic, I stand corrected since I can see it better, the white alternator wire wasn't cut as normally done, apparently why...
Yeah, the white wire originally went to the alternator, its been cut and connected to the isolator, the blue wire coming from the isolator will be...
The bottom piece, the finned one is a diode type battery isolator, used for isolating and charging an auxillary battery such as in a motorhome...
75 thru 78 20R used the clip on cap.
Best to follow the directions for the particular shim/gasket combo you use, but if I remember correctly the felpro headsaver shim used a sealer...
:waytogo: The spare mounted fuel tank and the cruise control are not OEM, someone has added them at some point, the rear axle is just a...
Normally yes, you would turn it around correctly to avoid confusion down the road or to another owner or mechanic. But!! I think I would carefully...
The numbers and arrows are factory and arrows should all face forward with #1 being the front
Its possible the ignition switch might be acting up, when the key is turned to the start position it sends power to the starter and the coil to...
Separate names with a comma.
