The rocker adjuster screws? are they screwed in or out to nearly max on the threads? Normally a 272 cam poses no valvetrain problems, but...
:waytogo:
78 does have an intank electric pump, and the relay is normally under the dash on the right side of the steering column.
I have an original OEM tan (sorta orangey brown) floor mat from a 78 4spd, in nearly new mint condition, probably won't find one in better...
I doubt the timing chain guide has any bearing on the problem, sounds to me more like a fuel issue, pressure regulator possibly? starts easy when...
Build your own, thats what I did on my 22R-SC :D
BYE, On my schematic it shows 3 different alternators in 82, ,,, 3 wire with external mechanical regulator white=B blue =N black=E 4 wire...
If it has a ridge worn around the fine tip, thats not the seat, seats in the carb, the needle has the ridge worn in it from being over tightened,...
Probably best to find a wiring diagram for your model to figure out for sure. On the older pre electronic stuff the wire would have come from...
What ^ said, head is warped or the journal clearances are way too tight.
Can't say for certain, but I imagine they would be the same, my 90 is black with white stripe.
Why not buy some, these are cheaper than the ones mentioned earlier, and probably less time consuming than trying to make them Ricka REAR DUALLY...
Besides the basics, air, fuel, spark, as already mentioned, and the fact the top end was apart, is everything plugged back in, distributor, tps,...
Good job, I,ve never sat down and tried to figure out the stock wiring on the relay, but I use the same relay on my rig rewired differently than...
What about something like this? its for the earlier trucks but might still be the same,,,,, TOYOTA HILUX RN20 RN25 PICK UP SHIFT BOOT INNER NEW |...
WoW!! Valve cover holddown stud maybe, and the nut torque is 8-11 ft# The head bolts are only 53-63 ft#
The box with small knobs under the hood sounds like it might be an aftermarket unit, and its hard to say what type or style of operation it might...
Yer welcome, good luck with your build :waytogo:
Air Flow Meter, its mounted next to the air filter box, the air is sucked through it from the filter to the engine, the flapper door inside...
I would start with the easy/cheap diagnosis first, check the seat bushing and the bushing on the end of the shift lever that fits into the shift...
Separate names with a comma.
