Anyone have one? Looking for one in good condition. I was going to go with a header but the header + new 2" exhaust + muffler and tip will run...
If anyone's in the PDX area and wants to check out a free Alice in Chains show, we're playing at the Washington County Fair tomorrow night from...
http://portland.craigslist.org/clk/pts/1848641614.html Not Mine!
Now that I have the suspension almost done, I need to tackle the carb. Was wondering what the baseline setup for a 20R is for the jetting. From...
OK we've all heard the reputation of the 22R, that it's bulletproof, goes forever, etc, etc.... so because of two factors: 1. Not a lot of...
I have some leftover parts that will be going to the dump mondaymorning unless someone wants them: - stock 18mm sway bar and brackets - smog /...
Anyone want to pickup where I've left off? I can give you the details, but it's almost all in my build thread. It's become more money than I...
Anybody use a Holley 350 before? I've used TONS of old 3310's and 1850's and know Holleys inside and out, just never used a 2v on a Toyota......
Ok I've been reading up on doing the EFI swap. Here's a few things I've learned: - The 22RE intake doesn't bolt onto a 20R. - There are 2...
Just throwing this out there, wondering if we could do something in the Portland / Vancouver area for August, maybe right under the Interstate...
So mine is seized, and I want to replace it. Looks like it bolts on from the TOP? So the only way to remove it is to take the bed off? I...
I've read a post on another board a while back about swapping a Tacoma radiator into an earlier truck. This guy did a 2rz swap into his (I think)...
http://www.autopartswarehouse.com/sku/Toyota/Pickup/Hedman/Headers/1980/SR5/4_Cyl_2-dot-2L/H5639400.html?tlc=Engine+%26+Drivetrain Thinking about...
I slapped my Jeep wheels on and they look great. Only issue is that on the back, the wheel curves in a little and hits the edge of the drum...
Well I have a bunch of stuff left over, with more to come. I was going to take this stuff to the dump, but I'll post 'em here for a while and see...
http://www.lceperformance.com/20R-22R-RE-EGR-Block-Off-Kit-3-pieces-p/1016010.htm I was going to just cut and drill some plates to do the EGR...
http://www.4crawler.com/4x4/CheapTri...ingChain.shtml Ok, so I installed the new chain, sprockets, and tensioner. I found the above write up...
Hey guys, just wondering, I wanted to grab a bed liner for my truck and it's only $15. what differences are there between the later 84-95 trucks...
OK I've got the oil pan off, and I need to pull the front cover. I can tell there's a dowel at the top in the middle to locate the front cover....
It looks like I need to replace the upper and lower control arm bushings in my truck, and BAD. I know how to do the uppers, they are pretty...
Separate names with a comma.
