I know old thread but I will throw in my 2 cents. I've done the powder coated frame thing before, and I will do it again. You need to find a good...
I'm not sure you will get the effect you are looking for just from exhaust. Exhaust can free up some power, and tuning it can help. But if the...
Got the bungs welded into the rear axle for Chad's truck. Started putting together the sheet metal lower links, and got the fish plates on the...
awesome truck. You're really doing it "right". I rarely say that.
I wish I was already driving it. Lol. There is so much stuff left to do... Discount weekend at pick n pull, so I picked up a few things I...
Thanks. Satchell Link. [img] [img] [img] [img]
Dooooo it! Lol. Glad I can inspire someone. Link bar. Trying to limit my use of square tube. [img]
Just keep in mind things like instant center, and roll center. Its pretty easy to install a 4-link and get bad results. There is some good info...
This is the link kit I was working on. Stock tank location raised a little, and all fits under the stock bed floor. [IMG] [IMG] [IMG] [IMG]
This is a cool project.
I'm not sure about trying to fit springs and a shock up front. I think you would end up with a very short spring, and probably not much travel. I...
Also with coilovers, I have not done it, but I make some upper arms that get rid of the cross shaft and stock shock mount, and a few guys have...
No 2-links...especially not if you're going to track it. I developed a Toyota specific 3-link kit a while back, but there was pretty much no...
I'm gonna leave the body as it sits. Trying not to get too involved in this truck.... Its obviously working, lol. Link bar teaser.... [img] [img]
Bob did the notch, all I did was finish the bottom of them off since he just did the top and sides. If I did them they would look more like the...
Spindles are powdercoated silver, read to go on. Lower arms are almost done. Plated the bottom of the notch Bob started so I could place the axle...
My neighbor was powder coating stuff for his truck, and asked if I had anything small I wanted silver. Only thing I could figure was ready was...
Ya I used to know the numbers, but once you get to the 90s trucks they are significantly wider (and roomier). I hated how limited my turning was...
Because the early trucks have a narrowed body than the new ones by a few inches, but they have the same track width. Lets me turn a little more.
I think you mean Flowmaster with the 40, 50 and 60 series? I don't think Magnaflow does that. I had a cat and a Magnaflow. It sounded good, but...
Separate names with a comma.
