Bench seat looks awesome. For some reason I like it in the first picture best. Just says old school and simple. Looks nice.
I might make like a basic DIY clutch pedal kit for these trucks to put it under the dash. I have to do mine soon and I've done it with every truck...
Thanks man. Finally working on my upper arms. [img]
Lower bars done. [img]
Lol every time I read the 671 it made me think of a screw blower.
That is a good idea with the torsion. I'm not sure if ti would be too big? I like the idea, but I actually have no torsion bars. I didn't take...
The S4 bar is chassis mounted. I figure I can make this work, just not sure if its too wide because the S4 has a wide track width. I will figure...
Its post #105 in this thread, page before this. I understand a good bit about sway bars, and if this one could be straight things would be really...
In my signature. Nor Cal, Cen Cal, So Cal.
Oh you mean on the sway bar I already have? The issue I see with that, is the coupler would need to be a bit longer than the sleeve I have on...
What do you mean broached? I looked into the splined type, but I need some very tight bends in the middle and I dont know they can be done that way.
I can ship it in about a week and a half. Usually I am faster, but I just used the last of my bushings and stuff doing a few recently. I will send...
I have a feeling I will end up doing the same, but I am going to try the cheap route first. Heat treating isnt the most wallet friendly thing.
That sounds okay, just really have lowers. Lot of unsprung weight. I do build 4-links, and with faster turnaround than most that do custom ones. I...
Really you should just build the frame off the clip...
Cool.
1/4" tube is really too thick, just so you know. And no, what I am saying is put a piece of 2x3 under the cab width wise, that is wider than the...
It really isn't the best idea. Once you cut the top off the frame it looses its structure, and it wont really be square after that. I've done it...
Just FYI, if you plan to run tube arms, you should probably try to get just the lowers if you can afford it. They are shaped much different than...
They are spring steel. You can weld to them, but the heat effects them and you loose some elasticity in the HAZ, but some of it is still...
Separate names with a comma.
