haha! it gets super hot over here especially after school. lol!!!
u wanna sell ur ac stuff?
+1 for hawaii guys doing there ow work in there garage chee!! haha and yup that truck is cherry and u got power windows?? u willing to trade i got...
make sure if theres an o2 sensor that it has the hole for it. other than that should be bolt on
drain the old fluid and put new fluid but put an extra qt or so, then under the truck there will be 2 small lines going in and out of the radiator...
try pull out one of the spark plugs and see if there ok (gap is nice , electrode still there, and the color, it should be like a brownish ashy...
does this serve a purpose other than emmisions? bcuz i wanna bypass and plug all that and remove it so i have a clean engine look. thanxs.
holy shet i think its 50+ a piece for those
if the spline count is the same jus use the 22r bellhousing and put it on the 20r trans case, im pretty sure thats the same.
u dont need to burn rubber anyways! all it does is ruin stuff, tires, gas, relationships with neighbors lol
keep in mind that if u lengthen or shorten that bar it might change the angle on the yoke and driveshaft.
uhm if u didnt have any problems with the truck pulling to one side or any alignment pobablems like that , i would put it back to jus how it was....
das soo sick!!! u should drop it so the wheels stick outside the fenders lol i love that wide stance! and are you gonna put a flat bed or the...
so do the door pannels from the 89-94 toyotas fit the 84-88 doors? if so whooo power windowwws
wooooow!!!!! thats one beefed battery you got there. lmao! and deep cycle isnt that for boats or cars that sit for long periods of time? i heard...
sounds pretty simple, and thats a unique idea!
^^ unless the weldings were looking like bird doodoo. lol or the diff was hooked up to a 154390whp 22r and tried burning rubber on flat 52 inch...
if thats stock for your truck just go to toyta and give them your vin, you'd be surprised what they still have.
oh bye i meant the bellousing off the 22r block on the tacoma trasmission case, not the tacoma bellhousing on a 22r.
lc engineering has like 2.5:1 final gear ratios . you should try those out. and since its a 2wd installing these should be a crackers, except for...
Separate names with a comma.
