Most of the stepside beds on 79-83 Toyota trucks were made by California Stepside. The beds were steel and the fenders were fiberglass. They wre...
I used to have an 18RG TRD Full race motor in my truck when I raced. The motor produced 360-375 HP and I ran twin Mikunis. The red line was 10,000...
I run twin 45 DCOE Webers on my full race / stroked 285HP L.C. Engineering Stage 5 Pro motor. I set up mine with larger chokes, etc. good to 6500...
The 20R head with factory electric pump is not worth anymore or less than a 20R Mechanical pump head in general unless a collector is restoring a...
I think it is for the emmission's system air pump or EGR system. Where is it located?
Contact Downey Off-Road. They have the parts you will need and the experience to guide you through it, whether it is 2 or 4 wheeled drive.
I am looking for a black 1983 SR5 4x4 console with lid in mint to excellent condition I do not need any mounting brackets.
Where did you find them? I would like to get a spare set. Also looking for a mint condition black 79-83 4x4 console, I took mine out when I raced...
Thank you for the info. Do you have a source or a contact where you purchased your alternators?
I was wondering if they told you that you had to run a heavier wire (8 Gauge) from the alternator to the battery; you still hook up your stock...
Look for a vacuum leak, lean carb, emissions system problems, etc.
Contact Downey Off-Road Mfg for small block Chevy engine conversions or Northwest Off-Road Specialties for small block Ford engine conversions....
Hi Bernie; Here is an idea for you. I have old customs and street rods and like you I wanted the radios to look factory but still have some new...
Did you look at the dash center speaker area? There are nuts / screws usually there. In addition some people sprayed upholery adhesive onto the...
I have an LC Engineering 22R 4 cylinder motor dynoed in at 285HP installed in my truck and I am really happy with it. Even though I have a 4x4, I...
I have always set my timing at 28-30 degress total advance at 2000-2500 RPM. You need a total advance type timing light (Sears) to set it though....
I ran a race prepared 18RG motor with twin Mikunis when I raced my truck. It put alot of power out, Redline was 10,000 RPM, and it produced better...
You can buy a flex fan at your local speed shop or online. They make fans that bolt onto the Toyota pulley. Your brake problem is most likely...
I have photos of my truck in the Reader's Ride section of Mini Truck Magazine, Truckin Magazine and Sport Truck Magazine.
I am an older Toyota mini trucker, most of you probably could be my grandsons:lol: I am trying to make a decision about what to do with my truck...
Separate names with a comma.
