As much as I love and use rivnuts for various cover plates and light duty brackets, I wouldn't use them for this application. Even if you use...
I misspoke. It's one of the oil pump bolts. Sorry; this is the bolt I was thinking of. Picture is from 1979 CelIca FSM.
Since we're talking about "that bolt" on the cover, did you put sealant on the bolt? It might be worth it to get the bolt from the dealer...
Yeah... something is very wrong. Since replacing the switch did nothing, I guess it's safe to assume the switch was/is not the problem. How did...
Hmmmm... sounds more like you have an issue with your ignition switch and/or wiring. When you turn the key into the "START" position, the oil...
The story goes... Toyoda is the founder's actual name. But, written in katakana, a Japanese "alphabet", it results in 10 brush strokes. Eight is...
Instead of flat steel bar, I would use at least angle iron or, preferably, some C-channel steel; something with a vertical wall for rigidity....
Exhaust leaks, whether bad exhaust manifold gasket or cracked header, usually makes a loud ticking sound like a rod knocking or a diesel engine. I...
Actually, it may turn out that it was a good thing you forgot your tester. If you had tested it, you wouldn't have bought it. Now, after a few...
If it has a carb then, if I'm not mistaken, the O2 sensor just controls the exhaust port air injection system and won't affect fuel mixtures....
LOL I bought that same tip for my GF's car. Gotten find it and install it one of these days...
Oh, that's right. It's the "runner" part they used... This thread reminded me of something: there is a magazine dedicated to Toyota 4WD trucks....
You don't have to start with a 4WD truck. Back in the day, before Toyota sort of hijacked the "forerunner" name for their mini-SUV, a FORErunner...
Oh, yeah. Thanks. I only mentioned the bung at the base of the carb for information. Also, it looks like OP's car does have a check valve in the...
Had to dig out my manual... Jetas is correct. Just plug the PCV hose directly into the IM, no check valve. It looks like you took a lot of...
Just a word of caution. Be careful of "just whatever". From what I've read, don't mix the GM Dexcool with other coolants. The combination turns...
Oops. You're right. Forgot about that.
What I was meant is, is the bottom of the block the square (looking from the side) end or angled end? That is, could the block be installed upside...
"Pushed the driveshaft too far forward". Is the angled face on the bottom (against the springs) or on top (against the axle)? If the angled face...
I don't remember how close the tank is to the drive train. I know it's tight but I don't think it was that tight... Something just occurred to...
Separate names with a comma.
