Why would you want to delete them? Just asking the obvious question.
I still run that trans. You might check the rest of the linkage in front of the firewall. I never noticed anything like that, but my old...
I love the polished head and parts. I thought about it, but wasn't sure how long it would stay that way.
Welcome!
You already know what I think. This is the first time I've seen the MMW's. Had to look them up. I can't think of any reason to hate on them,...
I can't remember, I'll have to measure it. Runs in my head that it might be the 6.75"? The bag contains a BIP for ignition spark control.
Is that a pic of the actual engine? Looks clean. Where are you located?
Both drilled and slotted rotors are old school tech for old school pads. The new tech pads don't rely on holes for off gas venting or slots for...
I keep going back to the Minitruckin Magazine article from years back that addressed link suspensions. They barely covered the reverse setup, but...
It doesn't do burn outs... at all. Kinda disappointing actually. During a launch, it doesn't really lift or lower the rear end much. It just...
Like a color matched painted bumper? ...Specifics...
Not yet. Doesn't mean it can't happen, but it hasn't. My fear is that when it does, it will be violent, now that I've added a couple hundred...
Not really. The turbo center section I got from Precision lasted only about 24 hours before it was toast. I've had the worst luck with turbos so...
Somewhere just above 11.1 million units, by Toyota's numbers... Toyota Global Site | Number of Vehicles Produced in Japan by Model
Well, hundreds of thousands of these things would say otherwise? Don't know what else to tell you. You could ping the ends of the yokes with a...
It's not unusual for them to push in or out by hand, but wasn't there a set of C clips that came with it to lock the caps into place?
Yeah, there really isn't a "cheap" alternative. Save up some money and do it right. You won't regret it. I've run an AZ OB2 for 6 years now...
There's no "squeezing" when it comes to wheel bolt patterns. Even a 5x112 won't fit a 5x114, and that's only 2mm overall. That 1/4" is around...
I had a dump stick open one day in my neighborhood. It was a sub 32 degree day, once I stopped and cycled for a few seconds, it never did it...
There are a hundred threads about shocks... Haha! Tons of good info. But carry on.
Separate names with a comma.
