Forgot to get to point- measure all journals on crank. If within specs and no oblongation or serious grooving you can probably run it.
These cranks are stout and wear resistant. I believe they are steel as opposed to cast iron? I pull a rebuilder apart that was hashed on; cracked...
I'm in the middle of a 22r and 5 speed swap in a 74. For being a Toyota to Toyota it's a PITA, but many probs can be avoided if the original trans...
These worthless ****ing forums...
Yeah dude, a throwout bearing is going to scream murder when the fork isn't even hitting it to the ****ing pplate.
If you were anywhere near Portland, Or I would give you my old l42. Made a little bit of noise but I prob would have ran it had I not found the 5...
87 radiator fits after drilling new mounting holes. 74 was at least a core thicker but newer rad clears clutch fan, barely. Must install fan...
Thanx for offer but I'll get this one going. Just had a prissy moment. The adaptation to motor and w55 is done so now it's just down bolting all...
endless labor on an old pos with a 90 hp forklift motor that prob won't run again FML. Belch.
Poor old Pathfinder went to a better place today so this is the wknd. Pic shows the mating of 87 to 74 motor mount. Drilled new hole and simply...
Many thanx! I'm assuming then that the 2 off back of timing cover are both outs (or +). For some odd reason the motor/trans ends at the exact...
Is it ok to block the coolant lines that normally flow through the intake mani? I would like to avoid deliberately heating the intake. If so how...
Haven't sussed out attaching pix with cell phone. Any ideas on doing that with Android? For time being I am loading the minor details to avatar...
Oops, little faith that is.
One can hopefully see in avatar pic where the mount has been dropped into and bolted to the bottom of xmember. This lines up surprisingly well...
It sits high on the stock motor mount brackets. Should be fine though. The orig tranny (l42?) was first option but it was making a fair bit of...
Retarding the ignition helps immensely. The more the better. I've passed dialed so far back the car was barely drivable. You will have to open the...
Thanks, man. I'll take any and all advice on this project. Didn't imagine swapping a 4 into a truck of the same make would be such a pain but too...
... And stupid cell phone won't allow me to attach pics. I have gotten quite a few ideas for this swap from this forum and owe gratitude to the...
Recently started this project and although the motor/trans are now physically in the truck it needs to be whipped with a wire feed; anything but a...
Separate names with a comma.
