cool thanks for the response.now i ordered a pacesetter header about 2 weeks ago..just got it..opened it up..and they sent me one that fits the...
is my 1981 sr5 longbed carbureted or fuel injected?
really? no ideas?
i just got some 16x8s at a "0" offset..think they'll fit?
occasionally when i step on the gas in gears 1-3, my engine cuts out/ sputters before catching and accelerating forward..what could this be?
whats the highest offset i can go with my '81?
http://sacramento.craigslist.org/pts/1937017553.html the motor has an upgraded catalytic converter and a 4-1 header. i called to see if it was...
ya i did happen to find a deal closer..how difficult is it to do an engine tranny swap? never done anything like it..
how much would shipping cost? complete motor and tranny? whats the condition of them? mileage?
the state with the most rules..sacramento ca
where can i find a cheap, reliable deal for both? prefer the 22r with a 5spd but would be open to a 22r/20r engine with the same tranny
..and so how do i adjust the torsion bars? no idea where they are located let alone messing with em lol. pictures to aid, perhaps?
might have to start snappin some pictures and turn this here into a build thread! =)
so what bushing material is more desireable? polyurethane or rubber? a 32/36 weber carb should run well, ya?
ive had a 1991 Nissan Maxima that was in good shape..until crashed had a 1999 Subaru Legacy Outback that i drove until it required both a new...
bought a truck and got it saftey checked..wat a lemon i scored! heres a list of diagnosed problems they found..how much should this cost me to...
and what size are those meshies you're running?
those sway-a-way bars..i could only find applications that fit '84 and newer..do they make one to fit my '81? and those rear "snubbers"..are they...
the gap between your rear wheel and fender is perfect! how can i get my front to match the back? ps-did the blocks affect the ride quality at...
id like to drop it 2-2 3/4" up front. ive got some 16x7 rims on the way and would like to close the gap between wheel and well a bit. any suggestions?
Separate names with a comma.
