like to keep jap engines in jap cars and vice-versa. is the sr20 possible in a toyota?
which one will be the most cost friendly, strongest and reliable? the 22r isnt puttin out enough juice for my likings..goin in an 81
oh, and ive hear about the angles..can cause severe injury if the angle is not correct..30 degrees is the most common but ive also heard 20...
the welding was what i was trying to avoid..any way around it? and if not..got any blueprints?
any idea on how to install this? its a 5-point Jaz harness that will be for the drivers seat only..'81 hilux sr5.. can i attach the shoulder...
now my next question is pretty repetitive but i cant seem to find the information im looking for: how to locate and adjust the torsion bars. is it...
i got it :) i was jacking up the leaf springs instead of the axle itself which was preventing me from getting the separation. that middle bolt i...
so i took the u bolts off and discovered that there is a bolt and nut in the middle of the leaf spring that screws into the axle..do i unscrew...
2" lowering blocks? 81' longbed...
might as well do a rb26..or a 454
thanks for the feedback..got em switched out today. lifted my truck up an inch tho!! am i able to lower the rear 6 inches without having any...
how do i "de-tension" the old ones so that they dont pop off and take out my eye? :) ive got some new monroe sensatracs id like to put on...
i agree..good choice in rims. what size?
how low can you go down before the crossmember becomes an issue? would i have clearance issues if i were to drop it 5 inches all around?
oh, and what about the header? i ordered a 22r Pacesetter but they sent me a 20r instead..will this now work on my vehicle?
awesome..im liking how simple this is sounding. so i would be able to re use all the nuts and bolts in the swap?
hmm well if i need to get one i will. how much and where? and so i can i just remove my 223r head and simply bolt on the new head and intake?
went to the pick n pull today and found a 1976 celica gt with a well preserved 20r motor. we snagged the head for $26..think it will work on my...
well i already installed 3in belltech leafs, just put 16x8 rims on there and would like to close the wheel-wheel well gap a bit more. thinking of...
dont intend to thread jack but is it possible to use 3in lowering leaf springs and then add a 2in drop block to the back as well?
Separate names with a comma.
