Thanks Sharwk
You can definitely do 5.25 or 6.5 subs in the doors, it'll be heavy with all the deadening and material of course. Check out dd audio 6.5in...
My w50 tranny had a hard front seal which did the same, gunked up my bell housing n soaked 1/8 of my clutch disc.
What was done to swap the 22r in, plus w50, pictures would be great. :) , reason asking is because I'm putting a 22re in mines at the moment
71 fender, needs repair 10$ 75 fender, needs light repair 15$ 71 rear bumper 20$ 75 rear bumper 10$ local pickup...
Coilovers aren't installed yet, I have been quite busy with things at moment not having the time or funds to do the install, I will definitey...
feel like dropping it some more haha, also feels good to join the enkei mesh club
finally got new wheels and tires, found some enkei 15x7 20+ for 100 on craigs. tires are 205/60-15 ohtsu fp6000(rebadge ze-512) [IMG]
Try to tow a full size trailer and have ideas of duallying a short cab toy
If its light enough, a rotary will do just fine, actually 71 is 2435 curb weight :)
Busted leaky boots, dried up, play in the ball joint section. It won't fall out, but it will have sloppiness,
Manual rack will definitely steer better than plugged power rack, not so sure about gear boxes however
Np, I have no clue which 3 leaf to remove from the leaf spring, someone might chime in on which leafs to remove on the 1 ton leaf spring. My best...
Change your springs to half ton springs or remove 3 leaf, you'll then be able to fit the u-bolts on. In my opinion, the 1 ton springs sit too low...
Wtb buy 8/18rc aftermarket header for 50-100, pm me if you have one. Thanks
If I remember right, 2rz 5 speed have relatively short 1st to 2nd gear. Now my w50 + 4.10 rear does 65mph at about little over 3000ish with...
You can put itb on any motor, dohc, sohc, ohv, flat, etc. you will need a appropriate ecu to run it however.
4 stock 69-72 steelies w/ hubcaps, 14x4.5, will only clear drums, will clear disc only with spacer, 60 obo local pickup sacramento ca surrounding...
I replaced 4 25a fuse in my sub amp
That's some nice product your making there. :)
Separate names with a comma.
