Dapper Lighting 6x7 Inch Classic Square Projector Kit | Dapper Lighting [IMG]
Looking good! Love those '80's graphics....looks like a highway with a sharp left and a right! Its like a anti-nascar graphic, lol
Both 8" rearends too... U joints are an easy place to start tho... if narrowed down to the rearend, don't worry about it...
Its common for the rearend to clunck and clang once its had some mileage/ wear and tear put on it. My dad's '86 4x4 has a little over 200k miles...
Since this is a new issue with your truck.... is it a constant now? Sounds like your truck might be getting too much egr. You can try plugging...
My solenoid was good in both trucks... but one truck the ground was bad and the other truck wasn't getting power.... Causing my no idle problems.
I'd have to look at my manual to get the specs, but the easy way to test it is to cut a piece of insulation out of both wires and while its...
There should be a green plug hanging down between the carb and your battery. It has 4 wires going to the carb. One is for your choke, two are for...
The headliner is usually installed before the windshield and back glass, so it will be tucked in on all 4 sides and 3-4 rods are threaded through...
Yeah, you won't get anywhere if your battery is toast....
You can bench test the starter and take a peek at your flywheel and the gear on the starter to see if there is anything obvious? TRUCK_ACTION...
Just "weird" that its happened to both of the carb'd toyota trucks I've owned.. an '81 and now my '86. Rigged em both, lol. I think it has to do...
I've had issues with my anti-diesel solenoid either losing power or ground.... I seem to b the only one I guess, since I've responded to a lot of...
1966 Toyota Stout Pickup
Welcome to TM! That runner is SICK! Body swap?
Pretty clean for a work truck! Welcome to TM :)
NM... I see rain in your pics...must not be in CA, lol!
Where are you located? Seen one on Sacramento CL last week...
Exactly! And good idea with the plug...
Paint the lens black to sheild light from shining straight back... That's what i'd do. Should b a simple install... one + one - wire.
Separate names with a comma.
