Wow, that's HUGE! Just a few sawzall blades to get through it! Looks like you used a plasma cutter too - but you used the sawzall to split it in...
Noice! I hope your project turns out well. Welcome!
Eek I need a tetanus shot! Run don’t walk hahaha. I sure hope you didn’t pay much for that I’d probably be making a Hilux chicken coop outta that...
common parts like this should be available on the shelf from most parts stores
with all the contours, I'm curious what you're using to sand down that trans housing with? by hand?
I’ve never seen one priced under like $50 and it was pretty beat up. Most are hovering around $100 it seems. Kinda weird it’s so expensive...
ACE Hardware usually carries the correct size metric hardware. Also Fastenal and Grainger usually stock them too
They're called "quarter wheelhouse covers". Hard to find, but there are some out there as NOS (new old-stock) and not cheap, like $40 ea side....
Just guessing - looks like you drill two holes (main spring mount and the locator pin), take it apart and install with the spring base inside...
All the charts online say 60.1 for 2wd Toyota pickups
I always thought it was the same gasket. My understanding is that 20r/22r/re are pretty much the same block/head external dimensions- just with...
I would likely splice a wire off the 15A lighter circuit. I think it’s the 3rd one down? where have others wired accessories for switched power...
Wow, nice truck. Sure you want to sell that? Prices are all over the place for good condition Toyota pickups, it's crazy how wide the range of...
Thanks I dunno where you were looking but I just Googled it and saw many adapters for going either direction between 5 and 4 lugs
In my 93 I installed Boston Acoustics as my front dash speakers. Not sure if they’re still available though but for such small speakers they sound...
Aside from machining to fit, I'd imagine you could also use a wheel spacer to get around the center hub bore conflict
Correct, the pinion angle will not change - but the operating angles of driveshaft will change. If you have issues, you can always add in angled...
Common way to swap to a different lug pattern involves a wheel spacer lug adapter, which is probably a minimum of ~1" thickness, so keep that in...
In general a lot of people favor steel blocks vs aluminum. I'd assume it's because metal will not fracture like aluminum would - I had a 4" block...
Sparkly :applause:
Separate names with a comma.
