Swapped the end of the driveshaft and it bolted right up. Had to redo the trans mount, trim the floor opening slightly, shorten the clutch slave...
There is no conversion joint available, I contacted Moog. I am having to change the end of the driveshaft to the larger yolk. Oh...
No ideas?
I swapped a 5 speed out of a 1991 pickup into my 1975 pickup. I used the tailshaft slip yolk from the 91, but the u-joint is larger than the one...
Sorry, will do
I didn't think of that Erwin. I replaced the points distributor with an electronic distributor, That is very possible. I'll check that. Thanks
I did this. I ensured the timing marks were right. It still wants more timing than 8. Maybe I’ll adjust the Weber and see if that helps. Thanks
I have a 1975 Toyota pick up with the 20R. When the timing is set at 8 degrees the distributor is adjusted Into the distributor lock down bolt as...
Thanks guys!
Hello all, I have a 1975 Toyota Hilux. I just rebuilt the brakes. Going to rebuild the steering. I see left and right outer, and INNER tie rod...
Looks like it might end up with a fuel cell.
It's a 75. not ready to spend 300 bucks on a new tank.
Is there a later model junk yard gas tank that will fit between the frame? What has everybody done for gas tank replacement?
Thanks Man, Got it sorted. Still doing wiring, down to the lights, then fuel system.
The larger distributor cap I needed is Advance Auto part number CAC1318. Rotor button DAA1151. Pick up coil MEA2318. Plugs...
I'm about 80% done with the wring harness, but the distributor I ordered was listed as a 1975+. The distributor bolted up perfectly, and I ordered...
[ATTACH]
[IMG]
The "new" distributor bolted up nicely. Working on making a new wiring harness for the entire truck now. Shouldn't be too bad, I like wiring.
Separate names with a comma.
