Most everything from Thailand is a reproduction. Buyer beware!!!!!
Good luck. !!!!!
That small of a difference shouldn’t be a problem. Your distributor should easily be able to accommodate that. I always ask members how their...
Double check your firing order.
The factory 5 speed for that year was a W50. Prone to breakage of the shift forks. A W58 is supposed to be a direct fit with some support and...
20R is a bullet proof engine. The L43 4 speed is also very durable. Unless there’s a mechanical problem, I’d keep the original drivetrain. There...
That the shitty 2 piece. They all leak. I’ve had to reseal mine twice. when your engine is running, vacuum is actually a “suction motion”....
Sounds like a vacuum leak somewhere. Connect a vacuum gage to a manifold vacuum source. (anywhere below the throttle plate). See what your getting...
Clutch master cylinder or slave cylinder. Try a bleed down of the entire system first. You may have picked up some moisture in your brake fluid...
Yes it’s possible. That’s not a factory number. It’s in the right area, but perhaps ground off for the new number. That’s the only place on the...
You left frame rail will have the Toyota chassis number etched into the section just forward of the A arm assembly.The first 2 letters followed by...
Not sure the 20R header will work on the 22RE. I believe the ports are different designs. I know the intakes are different.
Head was not milled. I think the replacement head bolts they’re making today lack sufficient thread depth to properly seal the block. I bought...
I retapped all threaded bores with a M12x1.25 bottoming tap. Then used compressed air to clean out any debris, followed by .38 caliber bore clean...
My truck is a transition year 1979. It has 4 headlights, so a 1978 mechanically for all purposes. I’ve had problems getting my head gasket to...
Don’t buy any products from Toyota parts deal.com. [ATTACH] I ordered a set of 10 oem head bolts at a cost of almost $90.00. After some delay...
Second a driveline shop. You might have to have a new driveshaft fabricated if there are no available adapters to modify your existing shaft. I...
You need to use a tap. Bottoming tap if you can find one. The lower threads of the bolt holes can become clogged over time. Take a thin...
White smoke means coolant is getting into the combustion chamber. If I had to guess I’d say the problem is with the head gasket. Do you see...
Take a look at trailer wheels. Most are 14” x 5 x 4.5 bolt pattern (same as Toyota). Many accept baby moon hubcaps. You might be able to get that...
Separate names with a comma.
