Not too familiar with carbs, but is there a stop screw that is there to stop the throttle lever when you arent on the gas? Maybe adjust it out some...
Very cool, this is what I like, the research and engineering to make things work with each other...cant wait to see more progress.
Where theres a will, theres a way...right?
Im not all that concerned with it. If my truck is parked, its laid out. The frame is on the ground...its not going anywhere.
Bagged truck has no ebrake..the suspension travel would pull the cable....
Factory 93 Pickup rear. The rotors are off a 04 Camry, rear. The hub bore has to be milled out 5mm large to fit the axle hub, then a bracket is...
So was it a full clip back frame? Or the "cut off the top" of a factory frame drop? If a full frame, I need pics of your cab mounts...pleeeze...
Probably not. I dont hit the air too much. Last truck was 2 viair 380s and a 5 gallon tank and it was fine... As far as bag location for the...
Oh. And for some stupid a$$ reason I didn't think things through back when I cut the bottom of the cab for the frame rails. I thought it would...
Then the cab was set on the frame so I could finally tell if the Trans tunnel was gonna hit or not..I didn't know because of the engine being...
Got a good bit done this wknd. Friday I went and bought some angle and 1" 3/16 wall square tubing. First thing I did was modify the engine cross...
I'm sure it's in here. But are traditional bd or stock floor..
Oh snap. What they get you for...? I got locked up and mine impounded yr before last lol
^^ Do you have a build thread with pictures ?
I dont think I have seen one...they attach to the LCA and seem like they would be really stressed to articulate that much between the frame and...
Yes, all joints are going to be braced with fishplates, and any place where flex may appear will be braced, gusseted and supported. This has been...
Lay rocker. But never drag...too much work to just destroy it.
Frames done...holds air too. Pumped it to 100 psi and it held it overnight. It didnt do that in the beginning, I had to chase quite a few...
Still not low enough.
Whys Toyota backwards on the 2nd pic?
Separate names with a comma.
