Instead of flat steel bar, I would use at least angle iron or, preferably, some C-channel steel; something with a vertical wall for rigidity....
Exhaust leaks, whether bad exhaust manifold gasket or cracked header, usually makes a loud ticking sound like a rod knocking or a diesel engine. I...
Actually, it may turn out that it was a good thing you forgot your tester. If you had tested it, you wouldn't have bought it. Now, after a few...
If it has a carb then, if I'm not mistaken, the O2 sensor just controls the exhaust port air injection system and won't affect fuel mixtures....
LOL I bought that same tip for my GF's car. Gotten find it and install it one of these days...
Oh, that's right. It's the "runner" part they used... This thread reminded me of something: there is a magazine dedicated to Toyota 4WD trucks....
You don't have to start with a 4WD truck. Back in the day, before Toyota sort of hijacked the "forerunner" name for their mini-SUV, a FORErunner...
Oh, yeah. Thanks. I only mentioned the bung at the base of the carb for information. Also, it looks like OP's car does have a check valve in the...
Had to dig out my manual... Jetas is correct. Just plug the PCV hose directly into the IM, no check valve. It looks like you took a lot of...
Just a word of caution. Be careful of "just whatever". From what I've read, don't mix the GM Dexcool with other coolants. The combination turns...
Oops. You're right. Forgot about that.
What I was meant is, is the bottom of the block the square (looking from the side) end or angled end? That is, could the block be installed upside...
"Pushed the driveshaft too far forward". Is the angled face on the bottom (against the springs) or on top (against the axle)? If the angled face...
I don't remember how close the tank is to the drive train. I know it's tight but I don't think it was that tight... Something just occurred to...
A picture says a thousand words... Looking at your first and second pics, you can see rubbing on the drive shaft as well as the base of the yoke....
Sounds like it might be easier, and maybe cheaper, to find someone to weld up the hole. You can then grind flat and polish yourself, later. I'd at...
LOL I was going to make a joke about this and then I kept reading and read this: Sigh... now I see why finding parts is getting harder...
I would pull them separately but re-install them bolted together as a unit.
Back when my truck was a daily (until 1999) I used 89 (mid-grade). Back then, 87 usually did not have the detergent/additive package premium did....
That was me. And yes, the smog legal Weber kit from Redline has a one-piece adapter for the 20R. I bought (but not yet installed) a kit for my...
Separate names with a comma.
