I'm like 95% sure that it does. It's been a long time since I've had a rig with power steering so I won't say 100%. :lol:
Some plastics don't take being dyed very well. Hit the wrecking yards and keep an eye out for late 80's - mid 90's corollas, camrys etc. They...
That cap is standard issue on older trucks. 88 and prior should all have them.
While I think running filters only is silly for a couple of reasons I don't see the lack of 1/2 pound of vacuum being the end of the world for the...
The gears will swap, the 3rd member will not.
If your engine is in good shape running a breather on the forward hole in the valvecover won't cause any oil mess issues. I've had engines with...
With that long water pump you're going to end up with the radiator in place of the grill or the engine sitting in the cab. Swap to a short style...
I'd simply take a grinder to the lower lip of the a arm and be done with it.
People pay money for stock steel wheels? :lol: I couldn't tell you how many sets I've sent to the scrapper over the years.
A simple picture of the front suspension will tell us all the info needed to know what's going on.
Yup it should only take a little bit to bring the idle up.
There is a idle air bleeder to the drivers side of the hottest body that will need a flat tip screwdriver to turn. If I remember right you'll...
Arp sells extended studs for a lexus ls300 (?) whatever the smaller 4 door rear wheel drive lexus car is from the late 90's-mid 2000's sue me I'm...
I run 1" out back and 1 1/2" front spacers on my autocross truck with zero issue. Clean the threads on the stock studs and use blue loctite when...
Flip the lower ballpoint back under and you'll gain some clearance there. I ground the hell out of my lower control arms, strut bars and upper a...
You won't find a shorter dust cap. If you need to go a bit shorter than the spindle will allow there is more than enough meat on the tip to give...
So put the dust cap back on and smack that bitch with a hammer till the center cap clears. :lol:
If you remove the dust cover will the center cap clear the spindle?
Looks like they'll fit real well. I wouldn't worry about rear spacers. Just cut the corners off the u bolt plates so they'll clear the wheel....
Tail housing from a w55/58 along with the output shaft would get the party started.
Separate names with a comma.
