yea, item #1 would be getting new shocks. If the noise is still there, keep chasing.
If you have side to side play, you need to further diagnost WHAT is loose. there are 4 tie rods, pitman arm, idler arm, and wheel bearings that...
Yep. sounds like the gears are worn. I'm in the same boat. reman gearboxes are listed from most parts places but I don't know about actual...
Code 27 is for the sub- (REAR) O2 sensor guys, OP even mentions it. The rear O2 sensor does not affect fuel trims, it is only for catalyst...
Yup, brass radiators are a thing of the past, low demand due to the price of copper so supply drops almost as fast. I agree the aluminum...
8" came in 4 speed manual 2wds (3.07 ratio) and , I've heard, 2wd v6s (3.4-3.5ish ratio). Looks like the axle seal is leaking too going by the...
All the newer toyotas (80s, 90s) use the same bolt patterm and engine mounts within a family. IE any R block should fit any bellhousing for any...
2900 @70 is stock gearing for a 4 cyl 5 speed... I'd consider a trade since I have what you're looking for and I wouldn't mind something a...
Depends on how warmed up the 318 is and how you drive (and how sticky your tires are). Over in the cressida/supra scene the rule of thumb is the...
gravel. lots and lots of gravel. It was wet too. [IMG] Stock springs, stock height. Didn't air up the shocks, never left the property. My...
Cig lighter turns off with the ignition key. The original radio memory wire should haf constant power. Otherwise just run a new fused wire from...
I just did the same thing to my truck but not the lazy way, removing all the old lines and joints. No welded plugs or blocked off T's. Partially...
AC control runs through it as well as the alternator control wires. Wires that go to the C1 or C2 (don't remember which. big, square, white on my...
89+ 2wd short wheel base are 13.5 gal according to everywhere I've seen but this thread. I've put 13 gal in mine. 17 or 17.5 gal for everything...
Can't watch your vid cause I'm at work but here's my $0.02: Check the dust cover on the trans rear housing, hte little sheet metal cylinder over...
In and of itself, the PAIR system doesn't help overall emissions. It's there to get extra oxygen in the exhaust on cold start, along with the...
You won't lift the head. You'll bend a rod first;) I've used the rope method before. I've used the ratchet strap method too (I used high...
they *should* be level. If the block is machined, it should be done with the timing cover to prevent that from happening. regular composite head...
Cummins. I guess R&D, running engine dynos. I did com. college then got a bachelors in auto tech. (both of which after spending 4 years in...
wallet, keys, phone, belt, leatherman wave, pedometer (b/c insurance gives a discount), work ID badge if a weekday. Funny thing semi-related...
Separate names with a comma.
