Recent Content by DannyEarl

  1. DannyEarl
    Post

    Dynamat alternatives?

    You can buy dynamat from amazon for alot cheaper than most places
    Post by: DannyEarl, Jan 3, 2010 in forum: Interior/Electronics
  2. DannyEarl
    Post

    truck cuts out but dosent die

    Don't just replace the fuel pump! At least not without some evidence that it's bad. I don't think there are too many problems with fuel pumps on...
    Post by: DannyEarl, Jan 3, 2010 in forum: Engine/Drivetrain
  3. DannyEarl
    Post

    stupid question

    Are the 2wd rotors two piece? I thought only the 4wd ones were.
    Post by: DannyEarl, Apr 23, 2009 in forum: Suspension/Chassis
  4. DannyEarl
    Post

    Cel 71; egr

    Apply vacuum to the EGR valve with the engine idling, use a hand vacuum pump. The engine should run rough and almost stall. If it doesn't, then...
    Post by: DannyEarl, Apr 18, 2009 in forum: Engine/Drivetrain
  5. DannyEarl
    Post

    Engine skipping

    I don't think you have a problem...
    Post by: DannyEarl, Apr 15, 2009 in forum: Engine/Drivetrain
  6. DannyEarl
    Post

    v8 swap

    I guess i should say if you would put a v8 in your toyota truck i'd say definitely go with a small block chevy. those are undoubtedly great...
    Post by: DannyEarl, Apr 15, 2009 in forum: Engine/Drivetrain
  7. DannyEarl
    Post

    CEL code 13 and 25

    Check the wiring harness that runs across the fuel rail. Sometimes these can rub and cause an intermittent short.
    Post by: DannyEarl, Apr 13, 2009 in forum: Maintenance/Repair
  8. DannyEarl
    Post

    Engine skipping

    why do you need to throttle it for 30 seconds when it's parked? if it runs good when you're driving it I wouldn't worry about it
    Post by: DannyEarl, Apr 13, 2009 in forum: Engine/Drivetrain
  9. DannyEarl
    Post

    v8 swap

    what other engines would you put in? If you want real low end torque and good horsepower for a truck i'd say a pushrod v8 is the way to go
    Post by: DannyEarl, Apr 13, 2009 in forum: Engine/Drivetrain
  10. DannyEarl
    Post

    smog and street legal crap

    what does "cage the cat" mean?
    Post by: DannyEarl, Mar 31, 2009 in forum: Engine/Drivetrain
  11. DannyEarl
    Post

    need help

    the pinion bearing might be a little loose. take the driveshaft off and hit the pinion shaft nut once with a half inch impact. doesn't take much.
    Post by: DannyEarl, Mar 27, 2009 in forum: Engine/Drivetrain
  12. DannyEarl
    Post

    engine noise

    sounds weird. maybe take a long section of hose, like heater hose, hold one end to your ear and probe around under the hood until you get to the...
    Post by: DannyEarl, Mar 18, 2009 in forum: Engine/Drivetrain
  13. DannyEarl
    Post

    Steering handling..

    what do you mean 'lose control'? something could be loose in the front end, or it could be a tire making it pull. usually a bad tie rod doesn't...
    Post by: DannyEarl, Mar 15, 2009 in forum: Maintenance/Repair
  14. DannyEarl
    Post

    New here, from milwaukee

    thanks guys. that pic is at my parents house. that's my dad's 40 ford coupe in the garage. he got it last year but it's been a hot rod for a...
    Post by: DannyEarl, Mar 12, 2009 in forum: Introduce Yourself
  15. DannyEarl
    Post

    whats this

    Thats a vent or a purge solenoid for the EVAP emissions system. i guess you could take it off and block the hoses if you wanted. the check...
    Post by: DannyEarl, Mar 12, 2009 in forum: Engine/Drivetrain