Alright guys, after having searching the web for used spindles (im poor so i couldnt afford new), i found some Superior Spindles in PA for cheap. I had them powdercoated and finally put em on yesterday. We tried to put it on a drive over snap on lift, but it was already too low and we had an RX7 on the scissor lift so we had to use good ol' jackstands. I also put 4" angled blocks from DJM...Wish I could afford some beefed tacos but i didnt wanna put that much money into it since im going to bag it anyway....Here they are!

 

Looking good. What wheels you running,

 

18" Panthers, they are a #038 i think, but i bought them from a buddy who needed money so they were cheap, the tires I had to put on the front cost more lol

 

^^this

 

if you dont mind me asking how much did you pay to get the spindles powdercoated?

 

You have the same setup I do! haha looks great!

 

Not a dime The plant my dad works at done it.

 

looks good man

 

Thanks folks. Maybe next time u c the yota it will have a lol patina....

 

Very well done man. Lookin good

 

Thanks y'all. We are now in the process of building my 4-link and notch. Anyone have any dimensions for a reverse 4-link setup it will help a ton. Also got a lil scrap sheet metal I'm going to bend and roll hopefully during memorial day weekend for my roll pan!

 

I have an 84 xtra cab.will the drop spindles go right on or are there any modifications that have to be done?I have stock rims and tires.