Change Connecting Rod Bearings.

Discussion in 'Engine/Drivetrain' started by FOKAI12, Jun 28, 2009.

  1. FOKAI12

    FOKAI12 Enthusiast

    Joined:
    Jun 7, 2009
    Messages:
    138
    Likes Received:
    0
    Location:
    GREW UP IN GUAM NOW IN VA.
    Truck:
    1992 Reg Cab
    What is the easiest way to change the Connecting Rod Bearings?
     
    FOKAI12, Jun 28, 2009
    #1
  3. SD YOTA

    SD YOTA Grand Toyotaholic

    Joined:
    Jan 30, 2007
    Messages:
    3,585
    Likes Received:
    30
    Location:
    san diego
    Truck:
    2000 Toyota Tacoma 2wd

    im assuming you mean with the block in the truck?? in all honesty, i think its "dooable" but would be worlds easier with the block out of the truck.... just my op. :shrug:
     
    SD YOTA, Jun 28, 2009
    #2
  4. thundering02

    thundering02 Addict

    Joined:
    Jun 22, 2009
    Messages:
    725
    Likes Received:
    0
    Location:
    Fenton 63026
    Seriously easier with the engine out, the last crank I handled was over 30 lbs. and balancing that with the rods and trying to bolt it all back together... not from underneath IMO
     
    thundering02, Jun 29, 2009
    #3
  5. 91HiLux

    91HiLux Enthusiast

    Joined:
    Jan 23, 2007
    Messages:
    210
    Likes Received:
    0
    Location:
    Paradise Valley, AZ
    Truck:
    1991 Toyota HiLux 4x4 RN101
    pull the engine out, take off the head and oil pan...
     
    91HiLux, Jun 29, 2009
    #4

Share This Page