installed new belltech spindles on my 84 last night and the wheels are so toed out we can't even drive it out of the garage! No alignment needed my @as!

 

Whenever you put drop spindles on you need to align your front end.. hell anytime you mess with or unbolt anything on your front end you need to have it aligned..

 

crank the tie rods on both sides to straighten the wheels out as best as you can and get it aligned.

 

I find it odd that they even told you no aligment needed... As stated anytime you work on the front end like that you always need to check if not adjust you aligment

 

Who told you their was no alignment needed? It's completely obvious just by looking at them that they will need one. Plus as everyone here has said, anytime you mess with suspension or steering components you will need an alignment.

 

I read it on stylintrucks website (I think) anyway we're going to adjust the tie rods tonight but the left wheel is toed out so bad idk if I'll have enough to get it back in line. Sorry for the bitch session btw lol the truck is giving me a lot of grief this past wkd.

 

trucks are like girlfriends, the bitch and give ya grief for a while but if ya keep hammering on em eventually they give it up and give ya a nice ride....