Use mlv(mass loading vinyl on floor/firewall to lower front and road noise, Ur truck already has deadening material used on floor boards. Only...
Goodbye 1" front bar, hello 1-1/4" bar [IMG] Finally went to the yard and got a 2wd jimmy/blazer bar, humongous compared to stock and 1", the...
There will be a old school jap fest may 3rd, see ya all there ;)
205/60-15 falken 512, 3in rear block, aprox 3-4 front. Not more than 3-4, but hope it helps. [IMG]
@/93tilinfinity/, I'm using a no name header, 2.25 piping to a trd muffler which is made by borla.
I have tried magnaflow and borla on the same 22re. The magna has a deep tone and borla is quiet, stock cam sounds like rice. I have a crower stg 3...
Reminds me that I need to get a new crank pulley /:
I used the site in my post as a reference, to find out for sure you'll have to go out to the wrecking yard and measure.
On my 71, if I didn't space the bar lower, the bar would have interfered with my radiator drain plug(you can see in the picture), 73 later doesn't...
Look at my thread on front sway bar, I used a s10 front that's available in 25mm up to 33mm on different model packages. The end links are...
I wouldn't be surprise if someone glued it on, I guess you'll have to work your way in into getting some clearance to see what is holding it in, I...
Use a thin rag and slide it through the crank which ever way the pin is facing, should come off, keep an eye on it if it springs off.
Updated my cooler speaker box Before [IMG] After [IMG] Before setup Oz audio setup played well, but been abused too hard for half a year, coil...
My 71, plenty of space, 69-78 should be similar interior. http://m.youtube.com/watch?v=4ek9DRj1p5k
In stock upper perch configuration, Qa1 shocks will work, but the coilover setup will be a challenge, for coil over setup, you will need to modify...
Good points, you will have plenty of space in the engine compartment, I don't think you'll have any issue with moving mass cause rn12s are very...
Nice project going on, what made u choose the 4ag?
Since I am having small leaks around the drivetrain, I decided to do a re-seal on tranny and axle, also redoing rear wheel bearings, all parts I...
Our 69-95 pickups have great footwell room for kick panel staging, I think it should sound good, just remember to reinforce those plastic panels...
This site has some kick pods if you don't want to cut open your door panels/metal Q Logic 86-95 Toyota Truck 6 1/2" Custom Speaker Kick Panel -...
Separate names with a comma.
